Rendering (animals) - Advantages and Disadvantages

Advantages and Disadvantages

The rendering industry is one of the oldest recycling industries, and made possible the development of a large food industry. The industry takes what would otherwise be waste materials and makes useful products such as fuels, soaps, rubber, plastics, etc. At the same time, rendering solves what would otherwise be a major disposal problem. As an example, the USA recycles more than 21 million metric tons annually of highly perishable and noxious organic matter. In 2004, the U.S. industry produced over 8 million metric tons of products, of which 1.6 million metric tons were exported.

Usually, materials used as raw materials in the rendering process are susceptible to spoilage. However, after rendering, the materials are much more resistant to spoiling. This is due to the application of heat either through cooking in the wet rendering process or the extraction of fluid in the dry rendering process. The fat obtained can be used as low-cost raw material in making grease, animal feed, soap, candles, biodiesel, and as a feed-stock for the chemical industry. Tallow, derived from beef waste, is an important raw material in the steel rolling industry providing the required lubrication when compressing steel sheets. The meat and the bones (which are in a dry, ground state) are converted to what is known as meat and bone meal.

In the absence of the rendering industry, the cost of waste disposal of waste animal material would be very high and would place a significant economic and environmental burden on areas involved in industrial scale slaughtering. This cost may manifest itself through the expensive use of sanitary landfills, incinerators and other similar waste disposal techniques without yielding profit directly out of it leading to the incurrence of opportunity costs. Using substitute products to rendering products may not necessarily prove to be lesser in cost.