Brace Position - Types of Brace Position

Types of Brace Position

There are many different ways to adopt the brace position, with many countries adopting their own version based on research performed by their own aviation authority or that of other countries. There is commonality among all brace positions despite these variations. For a forward seated passenger wearing only a lap belt, common recommendations for the brace position include:

• Placing the head on, or as close as possible to, the surface it is most likely to strike. (For example, the bulkhead or seat in front.)
• Having the passenger lean over to some degree to avoid jackknifing or submarining.
• Placing the feet flat on the floor.

In the United Kingdom, following the Kegworth air disaster in 1989, the UK Civil Aviation Authority contracted an engineering consultancy, Hawtal Whiting Structures, to perform computer based analytical investigation to optimise the brace for impact position for forward-facing passengers. This was supported by medical information from the University of Nottingham and testing at the Institute of Aviation Medicine.

The brace position as set out to airlines in the UK for passengers in forward-facing seats is based on extensive analytical work arising from Kegworth. It is subtly different from that in the United States and some other countries. Passengers should place their feet and knees together with their feet firmly on the floor (either flat or on the balls of their feet) and tucked behind the knees to prevent shins and legs being broken against the base of the seat in front. They should bend as far forward as possible, resting their head against the seat in front if it is within reach and place their hands on the back of their head, with the hands one on top of another (rather than interlocked). Their elbows should then be brought in. This prevents both flailing of the arms in the crash sequence and protects the head from flying debris. The head should be as far below the top of the seats as possible to prevent injury from any collapsing overhead compartments.

The brace procedure for the forward-facing seat in the United States is similar to that of the UK, but rather than placing the hands on the back of the head, passengers are advised to place them on the top of the seat in front, one hand holding the other wrist and resting the head in the space between the arms. If the seat in front is not within reach then passengers are advised to either grab their ankles or place their hands under their legs and grab the opposite forearm.

Most experts will say that maximum protection for a forward-facing seat is when the passenger is able to pre-position their head on the surface they are likely to impact (e.g., seat back or bulkhead), as the risk of head trauma is significantly reduced during the crash. Reducing head trauma may also help the passenger stay conscious, which is also essential for rapid evacuation after the crash.

Flight attendant brace positions are somewhat different due to the design of aircraft jumpseats. So far, there has been little research into the best brace position for flight attendants, though airlines have adopted positions that are very similar to one another.

In rear-facing seats, the attendant should be sitting with their back and head firmly against the back of the jumpseat, their knees and feet together and slightly in front of or behind the knee (depending on the individual airlines procedures) - commonly referred to as "toes to tail". In European carriers, the hands can be placed behind the head and hands one on top of the other and the elbows brought in to meet, taking care that the forearm does not cover the ear and restrict hearing. This position provides the flight attendant protection to the face from any flying debris (as it will impact their elbows) yet still provides them with the ability to view the cabin and not muffle their commands. In the United States, the Federal Aviation Administration (FAA) does not recommend placing the hands behind the neck as their research suggests such actions can cause unnecessary loading on the neck and spine during an impact. Instead, US flight attendants are typically taught to sit on their hands, palms facing the ceiling, underneath their upper legs. Other variations include clasping the hands on the knees or using one arm to "hug" the opposing arm.

For forward-facing jumpseats, the position is exactly the same but with the feet behind the knees, with some airlines requiring flight attendants to tuck their chin in to their chest ("bow to the captain") to reduce the likelihood of whiplash injuries.

There is also a third brace position for flight attendants, and that is the "normal" brace position. This is adopted by the attendant for every take off and landing and provides them with protection from any sudden emergencies and allows them to adopt the full brace position quickly should they need to. The only difference between the normal brace and the full brace position is that the attendants will either fold their arms across their stomach or immobilize them by placing their hands under their thighs with the palms up. This position forms part of every flight attendant's "sixty second review" - a technique being adopted by airlines whereby the attendant will go over various factors in their head during the take-off and landing sequence. Things such as "how do I open my door?", "where is the next nearest exit?", "am I over land or water?" and "what commands will I shout" are just a few of the questions an attendant will ask themselves. The belief is that this mental review focuses the attendant on the safety-critical role they have during take-off and landing and will result in faster decision making and adaptation to the scenario.

Newer brace positions are being adopted by many U.S. airlines in which the flight attendants do not sit on their hands. Instead, they place their hands flat on top of their thighs. This new position is being adopted because in the event of a crash, sitting on hands can cause injury and/or crushing.