Edge Quality
Edge quality for water jet cut parts is defined with the numbers 1 through 5. Lower numbers indicate rougher edge finish; higher numbers are smoother. For thin materials, the difference in cutting speed for quality 1 could be as much as 3 times faster than the speed for quality 5. For thicker materials, quality 1 could be 6 times faster than quality 5. For example, 4″ thick aluminium Q5 would be 0.72 ipm (18 mm/min) and Q1 would be 4.2 ipm (107 mm/min), 5.8 times faster.
Read more about this topic: Water Jet Cutter
Famous quotes containing the words edge and/or quality:
“screenwriter
Listen, little Elia: draw your chair up close to the edge of the precipice and I’ll tell you a story.”
—F. Scott Fitzgerald (1896–1940)
“The past is interesting not only for the beauty which the artists for whom it was the present were able to extract from it, but also as past, for its historical value. The same goes for the present. The pleasure which we derive from the representation of the present is due not only to the beauty in which it may be clothed, but also from its essential quality of being present.”
—Charles Baudelaire (1821–1867)