Thermal Spraying - Detonation Thermal Spraying Process

Detonation Thermal Spraying Process

The Detonation gun basically consists of a long water cooled barrel with inlet valves for gases and powder. Oxygen and fuel (acetylene most common) is fed into the barrel along with a charge of powder. A spark is used to ignite the gas mixture and the resulting detonation heats and accelerates the powder to supersonic velocity down the barrel. A pulse of nitrogen is used to purge the barrel after each detonation. This process is repeated many times a second. The high kinetic energy of the hot powder particles on impact with the substrate results in a build up of a very dense and strong coatings.

Read more about this topic:  Thermal Spraying

Famous quotes containing the words spraying and/or process:

    [Ognev] recalled endless, heated, purely Russian arguments, when the wranglers, spraying spittle and banging their fists on the table, fail to understand yet interrupt one another, themselves not even noticing it, contradict themselves with every phrase, change the subject, then, having argued for two or three hours, begin to laugh.
    Anton Pavlovich Chekhov (1860–1904)

    ... geometry became a symbol for human relations, except that it was better, because in geometry things never go bad. If certain things occur, if certain lines meet, an angle is born. You cannot fail. It’s not going to fail; it is eternal. I found in rules of mathematics a peace and a trust that I could not place in human beings. This sublimation was total and remained total. Thus, I’m able to avoid or manipulate or process pain.
    Louise Bourgeois (b. 1911)