TCP Congestion Avoidance Algorithm - TCP Tahoe and Reno

TCP Tahoe and Reno

To avoid congestion collapse, TCP uses a multi-faceted congestion control strategy. For each connection, TCP maintains a congestion window, limiting the total number of unacknowledged packets that may be in transit end-to-end. This is somewhat analogous to TCP's sliding window used for flow control. TCP uses a mechanism called slow start to increase the congestion window after a connection is initialized and after a timeout. It starts with a window of two times the maximum segment size (MSS). Although the initial rate is low, the rate of increase is very rapid: for every packet acknowledged, the congestion window increases by 1 MSS so that the congestion window effectively doubles for every round trip time (RTT). When the congestion window exceeds a threshold ssthresh the algorithm enters a new state, called congestion avoidance. In some implementations (e.g., Linux), the initial ssthresh is large, and so the first slow start usually ends after a loss. However, ssthresh is updated at the end of each slow start, and will often affect subsequent slow starts triggered by timeouts.

Congestion avoidance: As long as non-duplicate ACKs are received, the congestion window is additively increased by one MSS every round trip time. When a packet is lost, the likelihood of duplicate ACKs being received is very high (it's possible though unlikely that the stream just underwent extreme packet reordering, which would also prompt duplicate ACKs). The behavior of Tahoe and Reno differ in how they detect and react to packet loss:

• Tahoe: Triple duplicate ACKS are treated the same as a timeout. Tahoe will perform "fast retransmit", halve the slow start threshold, reduce congestion window to 1 MSS, and reset to slow-start state.
• Reno: If three duplicate ACKs are received (i.e., four ACKs acknowledging the same packet, which are not piggybacked on data, and do not change the receiver's advertised window), Reno will halve the congestion window (instead of setting it to 1 MSS like Tahoe), halve the slow start threshold, perform a fast retransmit, and enter a phase called Fast Recovery. If an ACK times out, slow start is used as it is with Tahoe.

Fast Recovery. (Reno Only) In this state, TCP retransmits the missing packet that was signaled by three duplicate ACKs, and waits for an acknowledgment of the entire transmit window before returning to congestion avoidance. If there is no acknowledgment, TCP Reno experiences a timeout and enters the slow-start state.

Both algorithms reduce congestion window to 1 MSS on a timeout event.