OBD-II PIDs - Modes

Modes

There are ten modes of operation described in the latest OBD-II standard SAE J1979. They are as follows (the $ prefix indicates a hexadecimal radix):
$01. Show current data
$02. Show freeze frame data
$03. Show stored Diagnostic Trouble Codes
$04. Clear Diagnostic Trouble Codes and stored values
$05. Test results, oxygen sensor monitoring (non CAN only)
$06. Test results, other component/system monitoring (Test results, oxygen sensor monitoring for CAN only)
$07. Show pending Diagnostic Trouble Codes (detected during current or last driving cycle)
$08. Control operation of on-board component/system
$09. Request vehicle information
$0A. Permanent DTC's (Cleared DTC's)

Vehicle manufacturers are not required to support all modes.

Each manufacturer may define additional modes above #9 (e.g.: mode 22 as defined by SAE J2190 for Ford/GM, mode 21 for Toyota) for other information (e.g.: the voltage of the Traction Battery in a HEV).

Read more about this topic:  OBD-II PIDs

Famous quotes containing the word modes:

    “Men and women are brothers and sisters; they are not of different species; and what need be obtained to know both, but to allow for different modes of education, for situation and constitution, or perhaps I should rather say, for habits, whether good or bad.”
    —Samuel Richardson (1689–1761)

    “There are two modes of transport in Los Angeles: car and ambulance. Visitors who wish to remain inconspicuous are advised to choose the latter”
    —Fran Lebowitz (b. 1951)

    “Without any extraordinary effort of genius, I have discovered that nature was the same three thousand years ago as at present; that men were but men then as well as now; that modes and customs vary often, but that human nature is always the same. And I can no more suppose, that men were better, braver, or wiser, fifteen hundred or three thousand years ago, than I can suppose that the animals or vegetables were better than they are now.”
    —Philip Dormer Stanhope, 4th Earl Chesterfield (1694–1773)