Nut (string Instrument) - Variations

Variations

Not all string instruments have nuts as described:

• Some guitars and mandolins, for example, have nuts that are just string spacers, with deep notches. These instruments use a zero fret, which is a fret at the beginning of the scale where a normal nut would be, which is higher than the other frets to provide the correct string clearance. The zero fret is often found on cheaper instruments, as it's much easier to set up an instrument this way; to make a proper nut requires that each string notch be carefully cut to the proper depth so that the string is neither too high, affecting overall string height and intonation of fretted notes, nor too low which causes a plucked or picked string to buzz against the frets. With a zero fret, the fret merely needs to be the right height. However, a zero fret also makes the sound of the open string very similar to the fretted note, where the nut itself, being made of a different material, has a different timbre if it is used instead of a zero fret. It is thus used for this reason on some high-end instruments.:

• Some fretted instruments have a compensated nut. This type of nut allows for better tuning across the instrument. The principle: given that strings are different thicknesses and have different tensions, the temperament of each fret is not 100% accurate for an equal temperament instrument. This is especially evident on the first few frets of an electric guitar. Many guitar players will note how 'open position' chords (Such as E, A, C, D and G) will never sound in tune with each other. A compensated nut aims to correct this, by staggering the starting position of each string according to thickness. While not a complete solution such as a True Temperament fretboard, there is a noticeable difference in tuning within chords. Many guitar companies, such as Music Man, and ESP include compensated nuts as standard on most of their instruments, and companies such as Earvana provide retrofittable types.

• Another type is a Locking Nut. This nut, usually used in conjunction with a locking vibrato system such as a Floyd Rose or Kahler, clamps the string before the node point. This results in a massive increase in tuning stability when using the vibrato bar. One large drawback however, is that the Locking Nut must be loosened using an Allen wrench should tuning need to be adjusted outside the range provided by the fine tuners on the bridge (if present)

• The erhu does not use a hard nut to define the speaking length of the open string, but rather a qiān jin (千斤) : a loop of string, or, less commonly, a metal hook.