Neutral Density Filter - Varieties

Varieties

A graduated ND filter is similar except the intensity varies across the surface of the filter. This is useful when one region of the image is bright and the rest is not, as in a picture of a sunset.

The transition area, or edge, is available in different variations (soft, hard, attenuator). The most common is a soft edge and provides a smooth transition from the ND side and the clear side. Hard edge grads have a sharp transition from ND to clear and the attenuator edge changes gradually over most of the filter so the transition is less noticeable.

Another type of ND filter configuration is the ND Filter-wheel. It consists of two perforated glass disks which have progressively denser coating applied around the perforation on the face of each disk. When the two disks are counter-rotated in front of each other they gradually and evenly go from 100% transmission to 0% transmission. These are used on catadioptric telescopes mentioned above and in any system that is required to work at 100% of its aperture (usually because the system is required to work at its maximum angular resolution).

Practical ND filters are not perfect, as they do not reduce the intensity of all wavelengths equally. This can sometimes create color casts in recorded images, particularly with inexpensive filters. More significantly, most ND filters are only specified over the visible region of the spectrum, and do not proportionally block all wavelengths of ultraviolet or infrared radiation. This can be dangerous if using ND filters to view sources (such as the sun or white-hot metal or glass) which emit intense non-visible radiation, since the eye may be damaged even though the source does not look bright when viewed through the filter. Special filters must be used if such sources are to be safely viewed.

An inexpensive alternative to professional ND filters is a homemade ND filter, made from a piece of welder's glass. This has the effect of a 10-stop filter.