M1911 Pistol - Design

Design

Browning's basic M1911 design has seen very little change throughout its production life. The basic principle of the pistol is recoil operation. As the expanding combustion gases force the bullet down the barrel, they give reverse momentum to the slide and barrel which are locked together during this portion of the firing cycle. After the bullet has left the barrel, the slide and barrel continue rearward a short distance.

At this point, a link pivots the barrel down, out of locking recesses in the slide, and brings the barrel to a stop. As the slide continues rearward, a claw extractor pulls the spent casing from the firing chamber and an ejector strikes the rear of the case, pivoting it out and away from the pistol. The slide stops and is then propelled forward by a spring to strip a fresh cartridge from the magazine and feed it into the firing chamber. At the forward end of its travel, the slide locks into the barrel and is ready to fire again.

The military mandated a grip safety and a manual safety. A grip safety, sear disconnect, slide stop, half cock position, and manual safety (located on the left rear of the frame) are on all standard M1911A1s. Several companies have developed a firing pin block safety. Colt's 80 series uses a trigger operated one and several other manufacturers, including Kimber and Smith & Wesson, use a Swartz firing-pin safety, which is operated by the grip safety.

The same basic design has been offered commercially and has been used by other militaries. In addition to the .45 ACP (Automatic Colt Pistol), models chambered for .38 Super, 9 mm Parabellum, .400 Corbon, and other cartridges were offered. The M1911 was developed from earlier Colt designs firing rounds such as .38 ACP. The design beat out many other contenders during the government's selection period, during the late 1890s and early 1900s, up to the pistol's adoption. The M1911 officially replaced a range of revolvers and pistols across branches of the U.S. armed forces, though a number of other designs have seen use in certain niches.

Despite being challenged by newer and lighter weight pistol designs in .45 caliber, such as the Glock 21, the SIG Sauer P220 and the Heckler & Koch USP, the M1911 shows no signs of decreasing popularity and continues to be widely present in various competitive matches such as those of IDPA, IPSC, and Bullseye.

Cautionary language against placing the index finger along the side of the gun to assist in aiming was included in the initial manual on the 1911 which was published in 1912. This is found in other military manuals on the 1911 up to the 1940s.