Linear Hashing - Algorithm Details

Algorithm Details

A hash function controls the address calculation of linear hashing. In linear hashing, the address calculation is always bounded by a size that is a power of two * N, where N is the chosen original number of buckets. The number of buckets is given by N * 2Level e.g. Level 0 => N; Level 1 => 2N; Level 2 => 4N.

address(level,key) = hash(key) mod (N * 2level)

The 'split' variable controls the read operation, and the expansion operation.

A read operation would use address(level,key) if address(level,key) is greater than or equal to the 'split' variable. Otherwise, address(level+1,key) is used. This takes into account the fact that buckets numbered less than split have been rehashed with address(level+1,key) after its contents split between two new buckets (the first bucket writing over the contents of the old single bucket prior to the split).

A linear hashing table expansion operation would consist of rehashing the entries at one slot location indicated by the 'split' variable to either of two target slot locations of address(level+1,key). This intuitively is consistent with the assertion that if y = x mod M and y'= x mod M * 2, then y'= y or y' = y + M.

The 'split' variable is incremented by 1 at the end of the expansion operation. If the 'split' variable reaches N * 2level, then the 'level' variable is incremented by 1, and the 'split' variable is reset to 0.

Thus the hash buckets are expanded round robin, and seem unrelated to where buckets overflow at the time of expansion. Overflow buckets are used at the sites of bucket overflow (the normal bucket has a pointer to the overflow bucket), but these are eventually reabsorbed when the round robin comes to the bucket with the overflow bucket, and the contents of that bucket and the overflow bucket are redistributed by the future hash function hash(key) mod (N * 2 level+1 ).

The degenerate case, which is unlikely with a randomized hash function, is that enough entries are hashed to the same bucket so that there is enough entries to overflow more than one overflow bucket (assuming overflow bucket size = normal bucket size), before being absorbed when that bucket's turn to split comes in the round robin.

The point of the algorithm seems to be that overflow is preempted by gradually increasing the number of available buckets, and overflow buckets are eventually reabsorbed during a later split, which must eventually happen because splitting occurs round robin.

There is some flexibility in choosing how often the expansion operations are performed. One obvious choice is to perform the expansion operation each time no more slots are available at the target slot location. Another choice is to control the expansion with a programmer defined load factor.

The hash table array for linear hashing is usually implemented with a dynamic array algorithm.