Die (manufacturing) - Wire Pulling

Wire Pulling

Wire-making dies have a hole through the middle of them. A wire or rod of steel, copper, other metals, or alloy enters into one side and is lubricated and reduced in size. The leading tip of the wire is usually pointed in the process. The tip of the wire is then guided into the die and rolled onto a block on the opposite side. The block provides the power to pull the wire through the die.

The die is divided into several different sections. First is an entrance angle that guides the wire into the die. Next is the approach angle, which brings the wire to the nib, which facilitates the reduction. Next is the bearing and the back relief. Lubrication is added at the entrance angle. The lube can be in powdered soap form. If the lubricant is soap, the friction of the drawing of wire heats the soap to liquid form and coats the wire. The wire should never actually come in contact with the die. A thin coat of lubricant should prevent the metal to metal contact.

For pulling a substantial rod down to a fine wire a series of several dies is used to obtain progressive reduction of diameter in stages.

Standard wire gauges used to refer to the number of dies through which the wire had been pulled. Thus, a higher-numbered wire gauge meant a thinner wire. Typical telephone wires were 22-gauge, while main power cables might be 3- or 4-gauge.