Installation
Crown molding is typically applied along the seams where ceiling meets wall. Usually it is not placed flush against the wall nor against the ceiling. Instead, when viewed from the molding's end (or as a cross-section), it, the ceiling, and the wall form a "hollow" triangle. This adds a difficulty to the installation process, namely the need for complex cuts to form corners where two walls meet.
There are two common ways to fashion inside corners. One is to use a compound miter saw to cut the ends of the corner pieces along two axes simultaneously. The other, called coping, is a two step process, first to cut a simple miter and then to use a coping saw to undercut the miters.
Many different companies now manufacture crown molding in materials such as plastic and foam. These typically are offered with corner blocks, and are popular with DIY home improvement enthusiasts.
Using a coped joint for interior corners saves you the trouble of having to determine and cut the exact inside degree measurement since most corners are not exactly 90/45 degrees. Outside corners must be mitered, but use care because not all outside corners measure true. Measure and cut accordingly. If the angle is not exactly 45/22.5 degrees use a corner measuring device or piece of scrap crown molding to obtain the right measurement before you make your final cut.
Read more about this topic: Crown Molding