Production
Cable harnesses are usually designed according to geometric and electrical requirements. A diagram is then provided (either on paper or on a monitor) for the assembly preparation and assembly.
The wires are first cut to the desired length, usually using a special wire-cutting machine. The wires may also be printed on by a special machine during the cutting process or on a separate machine. After this, the ends of the wires are stripped to expose the metal (or core) of the wires, which are fitted with any required terminals or connector housings. The cables are assembled and clamped together on a special workbench, or onto a pin board (assembly board), according to the design specification, to form the cable harness. After fitting any protective sleeves, conduit, or extruded yarn, the harness is either fitted directly in the vehicle or shipped.
In spite of increasing automation, in general, cable harnesses continue to be manufactured by hand, and this will likely remain the case for the foreseeable future. In part, this is due to the many different processes involved, such as:
- routing wires through sleeves,
- taping with fabric tape, in particular on branch outs from wire strands,
- crimping terminals onto wires, particularly for so-called multiple crimps (more than one wire into one terminal),
- inserting one sleeve into another,
- fastening strands with tape, clamps or cable ties.
It is difficult to automate these processes. However, these processes can be learned relatively quickly, even without professional qualifications. Thus, manual production remains more cost effective than automation. For certain vehicles, such as trucks, there are also a large number of variants (due to different configurations and the length of the vehicles), which produce very small batch sizes (as low as one). However, the number of variants has been decreasing in recent years due to the use of data bus technology, such as a CAN bus, in conjunction with intelligent control units. In spite of this, different variants are produced on the same assembly board. Even here, man has an advantage over machine, since he can change over to the different variants (no "re-programming" being required).
Pre-production, however, can be automated in part. This affects:
- Cutting individual wires (cutting machine),
- crimping terminals onto one or both sides of the wire,
- partial plugging of wires prefitted with terminals into connector housings (module),
- soldering of wire ends (solder machine), and
- twisting wires.
Testing the electrical functionality of a cable harness can be done with the aid of a test board. The circuit diagram data are pre-programmed into the test board, where harnesses can be tested individually or in multiple numbers.
Read more about this topic: Cable Harness
Famous quotes containing the word production:
“The myth of unlimited production brings war in its train as inevitably as clouds announce a storm.”
—Albert Camus (1913–1960)
“The repossession by women of our bodies will bring far more essential change to human society than the seizing of the means of production by workers.”
—Adrienne Rich (b. 1929)
“An art whose limits depend on a moving image, mass audience, and industrial production is bound to differ from an art whose limits depend on language, a limited audience, and individual creation. In short, the filmed novel, in spite of certain resemblances, will inevitably become a different artistic entity from the novel on which it is based.”
—George Bluestone, U.S. educator, critic. “The Limits of the Novel and the Limits of the Film,” Novels Into Film, Johns Hopkins Press (1957)