Design and Production
Brookes can be best identified by the presence of at least one band of wrought iron at the breech and a rough-finished, tapering barrel. The barrels were made of cast iron for ease of manufacture, but one or more wrought iron bands was welded around the chamber to reinforce it against the high chamber pressure exerted when the gun fired. Because no southern foundries had the capacity to wrap the rifles in a single band like the Parrott design, a series of smaller bands were used, each usually 2 inches (51 mm) thick and 6 inches (152 mm) wide. All of Brooke's rifles used the same seven-groove rifling with a right-hand twist. Most of Brooke's guns had a Gomer-style powder chamber, shaped like a truncated cone with a hemispherical tip, but the 6.4-inch rifles had a simple hemispherical powder chamber.
These weapons were manufactured at the Tredegar Iron Works (sometimes referred to as J.R. Anderson & Co, after owner Joseph Reid Anderson) in Richmond, Virginia and at Selma Naval Ordnance Works in Selma, Alabama.
Read more about this topic: Brooke Rifle
Famous quotes containing the words design and/or production:
“Westerners inherit
A design for living
Deeper into matter—
Not without due patter
Of a great misgiving.”
—Robert Frost (1874–1963)
“An art whose limits depend on a moving image, mass audience, and industrial production is bound to differ from an art whose limits depend on language, a limited audience, and individual creation. In short, the filmed novel, in spite of certain resemblances, will inevitably become a different artistic entity from the novel on which it is based.”
—George Bluestone, U.S. educator, critic. “The Limits of the Novel and the Limits of the Film,” Novels Into Film, Johns Hopkins Press (1957)