ALCO PA - History

History

Two models were offered: the 2,000 horsepower (1,500 kW) PA-1/PB-1 (built between September, 1946 and June, 1950); the 2,250 horsepower (1,680 kW) PA-2/PB-2 (built between April, 1950 and December, 1953)

Models popularly termed the PA-3/PB-3 were in fact only an upgrade of the PA-2/PB-2. The true PA-3/PB-3 model would have boasted 2,400 horsepower (1,800 kW), though none were ever built. Aside from the small power increase between the PA-1 and the PA-2, differences were minor. Externally PA-2s could be distinguished by the absence of the "eyebrow" trim piece on the grille behind the cab and the porthole window behind the radiator shutters. Internally, later PA-2 and PB-2 production featured a water-cooled turbocharger and other engine compartment changes, but these were frequently added to older models undergoing major repairs or overhauls.

Like its smaller cousin, the ALCO FA, the PA had distinctive styling, with a long, straight flat-tipped nose with a headlight in a square, slitted grille, raked windshields, and trim pieces behind the cab windows that lengthened and sleekened the lines. The overall design owed something to the Fairbanks-Morse Erie-built design, which had been constructed by ALCO's electrical equipment partner General Electric at their Erie, Pennsylvania plant. The majority of PA components were compatible with the FA.

Fans deemed the PA one of the most beautiful diesels and an "Honorary Steam Locomotive", as noted by Professor George W. Hilton in a book review in September, 1968 Trains Magazine. When accelerating, until the turbocharger came up to speed thick clouds of black smoke would pour from the exhaust stacks, due to turbo lag. Photographing a moving PA while smoking became a prime objective of railfans

The ALCO 244 V16 diesel prime mover proved to be the undoing of the PA: The engine had been rushed into production, and proved to be unreliable. The PA locomotives failed to capture a marketplace dominated by General Motors Electro-Motive Division and their E-units. The original Santa Fe three unit set #51L, 51A and 51B was repowered in August 1954 with EMD 16-567C engines rated at 1,750 hp (1,305 kW). This EMD repowering of the PAs was economically unfeasible and the remaining Santa Fe PAs retained their 244 engines. The later 251-series engine, a vastly improved prime mover, was not available in time for ALCO to recover the loss of reputation caused by the unreliability of the 244. By the time the ALCO 251 engine was accepted into widespread use, General Electric (which ended the partnership with ALCO in 1953) had fielded their entries into the diesel-electric locomotive market. General Electric eventually supplanted ALCO as a manufacturer of locomotives. ALCO's loss of market share led to its demise in 1969.