P-P Plot - Use

Use

As this example illustrates, if two distributions are separated in space, the P–P plot will give very little data – it is only useful for comparing probability distributions that have nearby or equal location. Notably, it will pass through the point (1/2, 1/2) if and only if the two distributions have the same median.

P–P plots are sometimes limited to comparisons between two samples, rather than comparison of a sample to a theoretical model distribution. However, they are of general use, particularly where observations are not all modelled with the same distribution.

However, it was found some use in comparing a sample distribution from a known theoretical distribution: given n samples, plotting the continuous theoretical cdf against the empirical cdf would yield a stair-step (a step as z hits a sample), and would hit the top of the square when the last data point was hit. Instead one only plots points, plotting the observed kth observed points (in order: formally the observed kth order statistic) against the k/(n + 1) quantile of the theoretical distribution. This choice of "plotting position" (choice of quantile of the theoretical distribution) has occasioned less controversy than the choice for Q–Q plots. The resulting goodness of fit of the 45° line gives a measure of the difference between a sample set and the theoretical distribution.

A P–P plot can be used as a graphical adjunct to a tests of the fit of probability distributions, with additional lines being included on the plot to indicate either specific acceptance regions or the range of expected departure from the 1:1 line. An improved version of the P–P plot, called the SP or S–P plot, is available, which makes use of a variance-stabilizing transformation to create a plot on which the variations about the 1:1 line should be the same at all locations.