Use
Tools with a tapered shank are inserted into a matching tapered socket and pushed or twisted into place. They are then retained by friction. In some cases, the friction fit needs to be made stronger, as with the use of a drawbar, essentially a long bolt that holds the tool into the socket with more force than is possible by other means.
Caution needs to be exercised in the usual drilling machine or lathe situation, which provides no drawbar to pull the taper into engagement, if a tool is used requiring a high torque but providing little axial resistance. An example would be the use of a large diameter drill to slightly enlarge an existing hole. In this situation, there may be considerable rotary loading. In contrast, the cutting action will require very little thrust or feed force. Thrust helps to keep the taper seated and provides essential frictional coupling.
The tang is not engineered to withstand twisting forces which are sufficient to cause the taper to slip, and will not infrequently break off in this situation. This will allow the tool to spin in the female taper, which is likely to damage it. Morse taper reamers are available to alleviate minor damage.
Tapered shanks "stick" in a socket best when both the shank and the socket are clean. Shanks can be wiped clean, but sockets, being deep and inaccessible, are best cleaned with a specialized taper cleaning tool which is inserted, twisted, and removed.
Tapered shank tools are removed from a socket using different approaches, depending on the design of the socket. In drill presses and similar tools, the tool is removed by inserting a wedge shaped block of metal called a "drift" into a rectangular shaped cross hole through the socket and tapping it. As the cross section of the drift gets larger when the drift is driven further in, the result is that the drift, bearing against the foremost edge of the tang, pushes the tool out. In many lathe tailstocks, the tool is removed by fully withdrawing the quill into the tailstock, which brings the tool up against the end of the leadscrew or an internal stud, separating the taper and releasing the tool. Where the tool is retained by a drawbar, as in some mill spindles, the drawbar is partially unthreaded with a wrench and then tapped with a hammer, which separates the taper, at which point the tool can be further unthreaded and removed. Some mill spindles have a captive drawbar which ejects the tool when actively unscrewed past the loose stage; these do not require tapping. For simple sockets with open access to the back end, a drift punch is inserted axially from behind and the tool tapped out.
Read more about this topic: Machine Taper
Famous quotes containing the word use:
“... it is use, and use alone, which leads one of us, tolerably trained to recognize any criterion of grace or any sense of the fitness of things, to tolerate ... the styles of dress to which we are more or less conforming every day of our lives. Fifty years hence they will seem to us as uncultivated as the nose-rings of the Hottentot seem today.”
—Elizabeth Stuart Phelps (1844–1911)