Addressing and Virtual Circuits
X.25 supports two types of virtual circuits, virtual calls (VC) and permanent virtual circuits (PVC). Virtual calls are established on an as-needed basis. For example, a VC is established when a call is placed and torn down after the call is complete. VCs are established through a call establishment and clearing procedure. On the other hand, permanent virtual circuits are preconfigured into the network. PVCs are seldom torn down and thus provide a dedicated connection between end points.
VC may be established using X.121 addresses. The X.121 address consists of a three-digit data country code (DCC) plus a network digit, together forming the four-digit data network identification code (DNIC), followed by the national terminal number (NTN) of at most ten digits. Note the use of a single network digit, seemingly allowing for only 10 network carriers per country, but some countries are assigned more than one DCC to avoid this limitation. Networks often used fewer than the full NTN digits for routing, and made the spare digits available to the subscriber (sometimes called the sub-address) where they could be used to identify applications or for further routing on the subscribers networks.
NSAP addressing facility was added in the X.25(1984) revision of the specification, and this enabled X.25 to better meet the requirements of OSI Connection Oriented Network Service (CONS). Public X.25 networks were not required to make use of NSAP addressing, but, to support OSI CONS, were required to carry the NSAP addresses and other ITU-T specified DTE facilities transparently from DTE to DTE. Later revisions allowed multiple addresses in addition to X.121 addresses to be carried on the same DTE-DCE interface: Telex addressing (F.69), PSTN addressing (E.163), ISDN addressing (E.164), Internet Protocol addresses (IANA ICP), and local IEEE 802.2 MAC addresses.
PVCs are permanently established in the network and therefore do not require the use of addresses for call setup. PVCs are identified at the subscriber interface by their logical channel identifier (see below). However, in practice not many of the national X.25 networks supported PVCs.
One DTE-DCE interface to an X.25 network has a maximum of 4095 logical channels on which it is allowed to establish virtual calls and permanent virtual circuits, although networks are not expected to support a full 4095 virtual circuits. For identifying the channel to which a packet is associated, each packet contains a 12 bit logical channel identifier made up of an 8-bit logical channel number and a 4-bit logical channel group number. Logical channel identifiers remain assigned to a virtual circuit for the duration of the connection. Logical channel identifiers identify a specific logical channel between the DTE (subscriber appliance) and the DCE (network), and only has local significance on the link between the subscriber and the network. The other end of the connection at the remote DTE is likely to have assigned a different logical channel identifier. The range of possible logical channels is split into 4 groups: channels assigned to permanent virtual circuits, assigned to incoming virtual calls, two-way (incoming or outgoing) virtual calls, and outgoing virtual calls. (Directions refer to the direction of virtual call initiation as viewed by the DTE—they all carry data in both directions.) The ranges allowed a subscriber to be configured to handle significantly differing numbers of calls in each direction while reserving some channels for calls in one direction. All International networks are required to implement support for permanent virtual circuits, two-way logical channels and one-way logical channels outgoing; one-way logical channels incoming is an additional optional facility. DTE-DCE interfaces are not required to support more than one logical channel. Logical channel identifier zero will not be assigned to a permanent virtual circuit or virtual call. The logical channel identifier of zero is used for packets which don't relate to a specific virtual circuit (e.g. packet layer restart, registration, and diagnostic packets).
Read more about this topic: X.25
Famous quotes containing the words addressing, virtual and/or circuits:
“A writer who writes, “I am alone” ... can be considered rather comical. It is comical for a man to recognize his solitude by addressing a reader and by using methods that prevent the individual from being alone. The word alone is just as general as the word bread. To pronounce it is to summon to oneself the presence of everything the word excludes.”
—Maurice Blanchot (b. 1907)
“Neither dead nor alive, the hostage is suspended by an incalculable outcome. It is not his destiny that awaits for him, nor his own death, but anonymous chance, which can only seem to him something absolutely arbitrary.... He is in a state of radical emergency, of virtual extermination.”
—Jean Baudrillard (b. 1929)
“The Buddha, the Godhead, resides quite as comfortably in the circuits of a digital computer or the gears of a cycle transmission as he does at the top of a mountain or in the petals of a flower.”
—Robert M. Pirsig (b. 1928)