Windsurfing - Boards and Gear

Boards and Gear

In the 1970s and 1980s, windsurfers were classified as either shortboards or longboards. Longboards were usually longer than 3 meters, with a retractable daggerboard, and were optimized for lighter winds or course racing. Shortboards were less than 3 meters long and were designed for planing conditions. However, this classification by length has become obsolete, as new techniques, designs, and materials have taken the sport in new directions.

Most modern windsurfers (1990s and later) are derived from the shortboard design, and are intended to be used ideally in planing mode, where the board is mostly skipping over the surface of the water, rather than cutting through, and displacing the water. Planing is faster and gives more maneuverability, but requires a different technique from the displacement mode (which is also referred to as slogging or schlogging). Generally, smaller (i.e., lower volume, shorter length, narrower width) boards and smaller area sails are used as the wind increases.

While windsurfing is possible under a wide range of wind conditions, most recreational windsurfers prefer to sail in conditions that allow for consistent planing with multi-purpose, not overly specialized, free-ride equipment. Larger (100 to 140 liters) free-ride boards are capable of planing at wind speeds as low as 12 knots if rigged with an adequate, well-tuned sail in the six to eight square meter range. The pursuit of planing in lower and lower winds has driven the development and spread of wider and shorter boards, with which planing is possible in wind speeds as low as 8 knots, if sails in the 10 to 12 square meter range are used.

Modern windsurfing boards can be classified into many categories:

• Freeride: Boards meant for comfortable recreational cruising (mostly straight-line sailing and occasional turning) at planing speed (aka blasting), mainly in flat waters or in light to moderate swell. They typically fall into the volume range of 90 to 170 liters. The so-called freeride sailing movement diverged from course racing as more recreational sailors chose to sail freely without being constrained to sailing on courses around buoys.
• Formula Windsurfing Class: Shorter boards up to one meter in width, for use in Formula Windsurfing races. See below for a more detailed description.
• Wave boards: Smaller, lighter, more maneuverable boards for use in breaking waves. Characteristically, sailors on wave boards perform high jumps while sailing against waves, and they ride the face of a wave performing narrow linked turns (bottom turns, cutbacks, and top-turns) in a similar way to surfing. Wave boards usually have a volume between 65 and 90 liters, with a length between 230 and 260 centimeters, and 50 to 60 centimeters in width. A general rule is for a sailor to use a wave board whose volume in liters is about the same as the sailor's weight in kilograms - more volume providing additional flotation for sailing in light winds, and less for high winds, where less volume is needed to achieve planing. In recent years, the average width of wave boards has increased slightly, as the length has shrunk, while the range of volume has been maintained the same more or less—according to board designers this makes wave boards easier to use under a wider range of conditions by sailors of differing abilities. The most common sizes of sails used with wave boards are in the range of 4.0 to 6.0 square meters, depending on the wind speed and the weight of the sailor.
• Freestyle boards: Related to wave boards in terms of maneuverability, these are wider, higher volume boards geared specifically at performing acrobatic tricks (jumps, rotations, slides, flips and loops) on flat water. Usually 80 to 110 liters in volume, and about 240 to 250 centimeters in length, with widths frequently in excess of 60 centimeters. Freestyle boards began to diverge more noticeably in design from wave boards in the early part of the 2000 decade, as aerial tricks (the Vulcan, Spock, Grubby, Flaka, and related New School maneuvers, almost all involving a jump-and-spin component) became the predominant part of the freestyle repertoire, superseding Old School moves, in which the board did not leave contact with the water.
• Slalom boards: Shortboards aimed at top speed, rather than maneuverability or ease of use.
• Beginner boards: (sometimes called funboards) these often have a daggerboard, are almost as wide as Formula boards, and have plenty of volume, hence stability.
• Racing longboards: Mistral One Design, or the Olympic RS:X class race boards.

There are many attempts to bridge a gap between two of these categories, such as freerace, freestyle-wave, freeformula, and so on.

The original Windsurfer board had a body made out of polyethylene filled with PVC foam. Later, hollow glass-reinforced epoxy designs were used. Most boards produced today have an expanded polystyrene foam core reinforced with a composite sandwich shell, that can include carbon fiber, kevlar, or fiberglass in a matrix of epoxy and sometimes plywood and thermoplastics. Racing and wave boards are usually very light (5 to 7 kg), and are made out of carbon sandwich. Such boards are very brittle, and veneer is sometimes used to make them more shock-resistant. Boards aimed at the beginners are heavier (8 to 15 kg) and more robust, containing more fiberglass.