Towpath - History

History

Early use of inland waterway transport used the rivers, and while barges could use sails to assist their passage when winds were favourable or the river was wide enough to allow tacking, in many cases this was not possible, and gangs of men were used to bow-haul the boats. As river banks were often privately owned, such teams worked their way along the river banks as best they could, but this was far from satisfactory. On British rivers such as the River Severn, the situation was improved by the creation of towing path companies in the late 1700s. The companies built towing paths along the banks of the river, and four such companies improved a section of 24 miles (39 km) in this way between Bewdley and Coalbrookdale. They were not universally popular, however, as tolls were charged for their use, to recoup the capital cost, and this was resented on rivers where barge traffic had previously been free.

With the advent of artificial canals, most of them were constructed with towpaths suitable for horses. Many rivers were improved by artificial cuts, and this often gave an opportunity to construct a towing path at the same time. Even so, the River Don Navigation was improved from Tinsley to Rotherham in 1751, but the horse towing path was not completed on this section until 1822. On the River Avon between Stratford-upon-Avon and Tewkesbury, a towpath was never provided, and bow-hauling continued until the 1860s, when steam tugs were introduced.

While towing paths were most convenient when they stayed on one side of a canal, there were occasions where it had to change sides, often because of opposition from landowners. Thus the towpath on the Chesterfield Canal changes to the south bank while it passes through the Osberton Estate, as the Foljambes, who lived in Osberton Hall, did not want boatmen passing too close to their residence. On canals, one solution to the problem of getting the horse to the other side was the roving bridge or turnover bridge, where the horse ascended the ramp on one side, crossed the bridge, descended a cirular ramp on the other side of the river but the same side of the bridge, and then passed through the bridge hole to continue on its way. This had the benefit that the rope did not have to be detached while the transfer took place. Where the towpath reached a lock, which was spanned by a footbridge at its tail, the southerm section of the Stratford-on-Avon Canal used split bridges so that the horse line did not have to be detached. The rope passed through a small gap at the centre of the bridge between its two halves.

One problem with the horse towing path where it passed under a bridge was abrasion of the rope on the bridge arch. This resulted in deep grooves being cut in the fabric of the bridge, and in many cases, the structure was protected by cast iron plates, attached to the faces of the arch. These too soon developed deep grooves, but could be more easily replaced than the stonework of the bridge. While bridges could be constructed over relatively narrow canals, they were more costly on wide navigable rivers, and in many cases horse ferries were provided, to enable the horse to reach the next stretch of towpath. In more recent times, this has provided difficulties for walkers, where an attractive river-side walk cannot be followed because the towpath changes sides and the ferry is no more.

Not all haulage was by horses, and an experiment was carried out on the Middlewich Branch of the Shropshire Union Canal in 1888. Following suggestions by Francis W. Webb, the Mechanical Engineer for the London and North Western Railway at Crewe Works, rails were laid along a 1-mile (1.6 km) stretch of the towpath near Worleston, and a small steam locomotive borrowed from Crewe Works was used to tow boats. The locomotive ran on 18 in (457 mm) gauge tracks, and was similar to Pet, which is preserved in the National Railway Museum at York. It pulled trains of two and four boats at 7 mph (11 km/h), and experiments were also tried with eight boats. The canal's engineer, G. R. Webb, produced a report on the expected costs of laying rails along the towpaths, but nothing more was heard of the project, and the advent of steam and diesel powered boats offered a much simpler solution. The mules which assist ships through the locks of the Panama Canal are a modern example of the concept.