Revolver - Design

Design

A revolver works by having several firing chambers arranged in a circle in a cylindrical block that are brought into alignment with the firing mechanism and barrel one at a time. In contrast, other repeating firearms, such as lever-action, pump-action, and semi-automatic, have a single firing chamber and a mechanism to load and extract cartridges into it.

A single-action revolver requires the hammer to be pulled back by hand before each shot, which also revolves the cylinder. This leaves the trigger with just one "single action" left to perform - releasing the hammer to fire the shot - so the force and distance required to pull the trigger can be minimal. In contrast, with a self-cocking revolver, one long squeeze of the trigger pulls back the hammer and revolves the cylinder then finally fires the shot. They can generally be fired faster than a single-action, but at the cost of reduced accuracy in the hands of most shooters.

Most modern revolvers are "traditional double-action", which means they are able to operate either in single-action or self-cocking mode. The accepted meaning of "double-action" has, confusingly, come to be the same as "self-cocking", so modern revolvers that cannot be pre-cocked are called "double-action-only". These are intended for concealed carry, because the hammer of a traditional design is prone to snagging on clothes when drawn. Most revolvers do not come with an accessory rail, which is used for mounting lights and lasers, except for the Smith & Wesson M&P R8 (.357 Magnum) and Smith & Wesson Model 325 Thunder Ranch (.45 ACP), respectively.

Most commonly, such guns have a 5- or 6-shot capacity, hence the common names of "six-gun" or "six-shooter". However, some revolvers have a 7- to 10-shot capacity, often depending on the caliber, and at least one revolver has a 12-shot capacity (the US Fire Arms Model 12/22). Each chamber has to be reloaded manually, which makes reloading a revolver a much slower procedure than reloading a semi-automatic pistol.

The alternatives are a replaceable cylinder, a speedloader which can reload all chambers at once, or a moon clip that holds a full load (or even half of one in the case of a half-moon clip) of ammunition and that is inserted along with the ammunition. In revolvers chambered for rimless cartridges, moon clips are normally required, though a few revolvers have been built with a special extractor with individual tabs to engage rimless cartridges. Another product known as a "speedstrip" cannot reload a completely empty revolver as rapidly as a speedloader, but is less expensive, flatter, and more flexible when it comes to partial reloads.

Compared to autoloading handguns, a revolver is often much simpler to operate and may have greater reliability. For example, should a semiautomatic pistol fail to fire, clearing the chamber requires manually cycling the action to remove the errant round, as cycling the action normally depends on the energy of a cartridge firing. With a revolver, this is not necessary as none of the energy for cycling the revolver comes from the firing of the cartridge, but is supplied by the user either through cocking the hammer or, in a double action design, by just squeezing the trigger. Another significant advantage of revolvers is superior ergonomics, particularly for users with small hands. A revolver's grip is not required to accommodate a magazine, and it can be designed or customized much more than a typical semi-automatic. Partially because of these reasons, revolvers still hold significant market share as concealed carry and home-defense weapons.

In general, revolvers stand up to long-term neglect better than semi-automatics, an example of neglect being the common scenario of a civilian who keeps a weapon for defense but rarely shoots or maintains it. A revolver can be kept loaded and ready to fire without fatiguing any springs and is not very dependent on lubrication for proper firing. Additionally, in the case of double-action-only revolvers there is no risk of accidental discharge from dropping alone, as the hammer is cocked by the trigger pull. However, a revolver is generally not as resistant to abuse as a semi-automatic (abuse meaning dropping the weapon, or allowing severe contamination by dirt or mud). The revolver's clockwork-like internal parts are relatively delicate and can become misaligned after a severe impact, and its revolving cylinder can become jammed by excessive dirt or debris.

Over the long period of development of the revolver, many calibers have been used. Some of these have proved more durable during periods of standardization and some have entered general public awareness. Among these are the .22 rimfire, a caliber popular for target shooting and teaching novice shooters; .38 Special and .357 Magnum, known for its police use; the .44 Magnum, famous from Clint Eastwood's "Dirty Harry" films; and the .45 Colt, used in the Colt revolver of the Wild West. Introduced in 2003, the Smith & Wesson Model 500 is one of the most powerful revolvers, utilizing the .500 S&W Magnum cartridge.

Revolver technology does live on in other weapons used by the military. Some autocannons and grenade launchers use mechanisms similar to revolvers, and some riot shotguns use spring-loaded cylinders holding up to 12 rounds. In addition to serving as backup guns, revolvers still fill the specialized niche role as a shield gun; law enforcement personnel using a "bulletproof" ballistic shield (Gun shield) sometimes opt for a revolver instead of a self-loading pistol, because the slide of a pistol may strike the front of the shield when fired. Revolvers do not suffer from this disadvantage. A second revolver may be secured behind the shield to provide a quick means of continuity of fire. Many police also still use revolvers as their duty weapon due to their relative mechanical simplicity and user friendliness.

With the advancement of technology and design in 2010 major revolver manufacturers are coming out with polymer frame revolvers like the Ruger LCR, Smith & Wesson Bodyguard 38, and Taurus Protector Polymer. The new innovative design incorporates advanced polymer technology that lowers weight significantly, helps absorbs recoil, and strong enough to handle +P and .357 Magnum loads. The polymer is only used on the lower frame and joined to a metal alloy upper frame, barrel, and cylinder. Polymer technology is considered one of the major advancements in revolver history because the frame has always been metal alloy and mostly one piece frame design.

Another recent development in revolver technology is the Rhino, a revolver introduced by Italian manufacturer Chiappa in 2009 and first sold in the U.S. in 2010. The Rhino, built with the U.S. concealed carry market in mind, is designed so that the bullet fires from the bottom chamber of the cylinder instead of the top chamber as in standard revolvers. This is intended to reduce muzzle flip, allowing for faster and more accurate repeat shots. In addition, the cylinder cross-section is hexagonal instead of circular, further reducing the weapon's profile.

Read more about this topic:  Revolver

Famous quotes containing the word design:

    We find that Good and Evil happen alike to all Men on this Side of the Grave; and as the principle Design of Tragedy is to raise Commiseration and Terror in the Minds of the Audience, we shall defeat this great End, if we always make Virtue and Innocence happy and successful.
    Joseph Addison (1672–1719)

    I always consider the settlement of America with reverence and wonder, as the opening of a grand scene and design in providence, for the illumination of the ignorant and the emancipation of the slavish part of mankind all over the earth.
    John Adams (1735–1826)

    For I choose that my remembrances of him should be pleasing, affecting, religious. I will love him as a glorified friend, after the free way of friendship, and not pay him a stiff sign of respect, as men do to those whom they fear. A passage read from his discourses, a moving provocation to works like his, any act or meeting which tends to awaken a pure thought, a flow of love, an original design of virtue, I call a worthy, a true commemoration.
    Ralph Waldo Emerson (1803–1882)