Powered Exoskeleton - Limitations and Design Issues - Joint Flexibility

Joint Flexibility

Flexibility is another design issue, and which also affects the design of unpowered hard shell space suits. Several human joints such as the hips and shoulders are ball and socket joints, with the center of rotation inside the body. It is difficult for an exoskeleton to exactly match the motions of this ball joint using a series of external single-axis hinge points, limiting flexibility of the wearer.

A separate exterior ball joint can be used alongside the shoulder or hip, but this then forms a series of parallel rods in combination with the wearer's bones. As the external ball joint is rotated through its range of motion, the positional length of the knee/elbow joint will lengthen and shorten, causing joint misalignment with the wearer's body. This slip in suit alignment with the wearer can be permitted, or the suit limbs can be designed to lengthen and shorten under power assist as the wearer moves, to keep the knee/elbow joints in alignment.

A partial solution for more accurate free-axis movement is a hollow spherical ball joint that encloses the human joint, with the human joint as the center of rotation for the hollow sphere. Rotation around this joint may still be limited unless the spherical joint is composed of several plates that can either fan out or stack up onto themselves as the human ball joint moves through its full range of motion.

Spinal flexibility is another challenge since the spine is effectively a stack of limited-motion ball joints. There is no simple combination of external single-axis hinges that can easily match the full range of motion of the human spine. A chain of external ball joints behind the spine can perform a close approximation, though it is again the parallel-bar length problem. Leaning forward from the waist, the suit shoulder joints would press down into the wearer's body. Leaning back from the waist, the suit shoulder joints would lift off the wearer's body. Again, this alignment slop with the wearer's body can be permitted, or the suit can be designed to rapidly lengthen or shorten the exoskeleton spine under power assist as the wearer moves.