Nikon F2 - Accessories

Accessories

Major accessories for the F2 included the Nikon MD-1 (introduced in 1971) and MD-2 (1973) motor drives, providing automatic film advance up to 5 frames per second, 6 if the mirror was locked up, plus power rewind. They both required a Nikon MB-1 battery pack holding 10 AA or LR6 batteries in two Nikon MS-1 battery clips. Note that the 5 frame/s rate required that the F2 have its mirror locked up and the MD-1 or -2 be loaded with two Nikon MN-1 nickel-cadmium rechargeable batteries. (These batteries are long since dead.) With the mirror operating, the maximum advance rate is 4.3 frame/s; with AAs, the rate is 4 frame/s. The addition of the MD-1 or MD-2 greatly increased the overall weight of the camera. With a fully loaded MD-2/MB-1 and 50mm lens, the F2 would weigh in at just over six pounds.

The F2 also accepted the lighter, cheaper and less capable Nikon MD-3 motor drive. The MD-3 did not have power rewind and had an advance rate of 2.5 frame/s with the standard MB-2 battery pack holding 8 AA or LR6 batteries. Optionally, it could reach 3.5 frame/s with an MB-1 battery pack with 10 AA or LR6 batteries; 4 frame/s with MB-1 and MN-1 nicad battery.

The F2 could also mount the Nikon MF-1 (33/10 feet/meters film = 250 frames; required two Nikon MZ-1 film cassettes) and MF-2 (100/30 feet/meters film = 750 frames; required two MZ-2 film cassettes) bulk film backs. These were very useful if a photographer had a motor drive mounted and needed to take more than seven seconds worth of photographs. Note that the MF-2 and its MZ-2 cassettes are very rare.

Starting in 1976, Nippon Kogaku introduced the Nikon Speedlight SB-2 (guide number 82/25 (feet/meters) at ASA 100), SB-5 (guide number 105/32 (feet/meters) at ASA 100), SB-6 (guide number 148/45 (feet/meters) at ASA 100) and SB-7E (guide number 82/25 (feet/meters) at ASA 100) electronic flashes. Note that the F2 did not use a standard ISO hot shoe to mount flash units. Instead, the SB-2, -6 and -7E mounted in a unique-to-Nikon-F-and-F2 hot shoe surrounding the film rewind crank. Manually rewinding film could not be done with a flash mounted in this shoe because the flash blocked the crank. Standard ISO foot flashes can be connected to the Nikon shoe via the Nikon AS-1 Flash Unit Coupler.

The Nikon ML-1 Modulite was a wireless infrared remote controller with a 200/60 feet/meters line-of-sight range. It was a two part device: a handheld transmitter plus a camera mounted receiver. Note that the receiver needed to be connected to a motor drive. The Nikon MW-1 was a similar device, but was larger and more powerful and used radio signals for a longer 2300/700 feet/meters obstructed view range. The MW-1 could also control three separate F2s by broadcasting three different codes.

The Nikon MT-1 intervalometer allowed completely untended time lapse photography. It could fire the F2 for a specific number of frames at a particular shutter speed at set time intervals.

Nippon Kogaku also made scores of minor accessories for the F2, such as camera straps, cases and bags, remote firing cords, eyecups, eyepiece correction lenses, supplementary close-up lenses, and lens hoods, filters and cases. In 1978, the complete Nikon photographic system of cameras, lenses and accessories totaled nearly 450 items priced in excess of US$110,000 – the most extensive and expensive in the world.