Mpemba Effect - Suggested Explanations

Suggested Explanations

Osborne observed that the top is warmer than the bottom in a beaker of water being cooled, the difference being sustained by convection. Blocking heat transfer from the top with a film of oil drastically slowed cooling. Also, the effect of dissolved air was accounted for by using boiled water. The beakers were also insulated from the bottom.

At first sight, the behaviour seems contrary to thermodynamics. Many standard physical theory effects contribute to the phenomenon, although no single explanation is conclusive. Several effects may contribute to the observation, depending on the experimental set-up:

• Evaporation: The evaporation of the warmer water reduces the mass of the water to be frozen. Evaporation is endothermic, meaning that the water mass is cooled by vapor carrying away the heat, but this alone probably does not account for the entirety of the effect.
• Convection: Accelerating heat transfers. Reduction of water density below 4 °C (39 °F) tends to suppress the convection currents that cool the lower part of the liquid mass; the lower density of hot water would reduce this effect, perhaps sustaining the more rapid initial cooling. Higher convection in the warmer water may also spread ice crystals around faster.
• Frost: Has insulating effects. The lower temperature water will tend to freeze from the top, reducing further heat loss by radiation and air convection, while the warmer water will tend to freeze from the bottom and sides because of water convection. This is disputed as there are experiments that account for this factor.
• Supercooling: It is hypothesized that cold water, when placed in a freezing environment, supercools more than hot water in the same environment, thus solidifying slower than hot water. However, supercooling tends to be less significant where there are particles that act as nuclei for ice crystals, thus precipitating rapid freezing.
• Solutes: The effects of calcium, magnesium carbonate among others.
• Thermal conductivity: The container of hotter liquid may melt through a layer of frost that is acting as an insulator under the container (frost is an insulator, as mentioned above), allowing the container to come into direct contact with a much colder lower layer that the frost formed on (ice, refrigeration coils, etc.) The container now rests on a much colder surface (or one better at removing heat, such as refrigeration coils) than the originally colder water, and so cools far faster from this point on.
• The effect of heating on dissolved gases; however, this was accounted for in the original article by using boiled water.
• Latent heat of condensation: During the cooling phase the cooler container is picking up more condensation than the warm container. This reduces the rate of cooling.