Gewehr 41
By 1940, it became apparent that some form of a semi-automatic rifle, with a higher rate of fire than existing bolt-action rifle models, was necessary to improve the infantry's combat efficiency. The Wehrmacht issued a specification to various manufacturers, and both Mauser and Walther submitted prototypes that were very similar.
The Mauser design, the G41(M), failed. Only 6,673 were produced before production was halted, and of these, 1,673 were returned as unusable. The Walther design, the G41(W), is in outward appearance not unlike the Gewehr 43. Most metal parts on this rifle were machined steel, and some rifles, especially later examples utilized the bakelite type plastic handguards. The Walther design was more successful because the designers had simply neglected the last two restrictions listed above.
These rifles, along with their G41(M) counterparts, suffered from gas system fouling problems. These problems seemed to stem from the overly complex muzzle trap system becoming excessively corroded from the use of corrosive salts in the ammunition primers, and carbon fouling. The muzzle assembly consisted of many fine parts and was difficult to keep clean, disassemble, and maintain in field conditions.
G41(W) rifles were produced at two factories, namely Walther at Zella Mehlis, and Berlin Luebecker. Varying sources put production figures between 40,000 and 145,000 units. These rifles saw a high attrition rate on the Eastern front.
Read more about this topic: German Military Rifles