Ford MEL Engine

Ford MEL Engine

Ford developed the MEL ("Mercury-Edsel-Lincoln") engine series as the replacement for the Lincoln Y-block V8 engine for use in large passenger car applications. These engines were produced in Lima, Ohio at Ford's Lima Engine plant. They were in turn replaced by the 385 series engines.

All MEL engines had wedge shaped combustion chambers formed between a flat head surface and an angle milled block deck (10 degrees off square with the bore axis), with the piston top determining the compression ratio and combustion chamber shape, similar to the Chevrolet Big-Block 348 combustion chamber, also introduced in 1958, and the later 409. Unlike the Chevrolet, which had staggered valves and scalloped or M shaped valve covers, the MEL valves were inline with shaft mounted rocker arms like the FE model Ford engines which were introduced at the same time. As with the previous generation V8's, an open runner intake manifold was used, requiring the use of a stamped steel lifter valley cover similar to that of the Pontiac V8 engines. Also, the intake manifold provided no exhaust crossover passage to warm the air/fuel mixture, relying solely on the heat riser mounted over the left exhaust manifold to provide heat for warming the air/fuel mixture.

The MEL was similar to the Ford FE, with the same oiling system, bolt patterns, and valve stems, but was even larger. The main bearings were 2.9 in (74 mm), while the rod bearings were huge at 2.6 in (66 mm). The connecting rod beam had a unique triangular shape with the shoulders for the bolts sitting low toward the cap mating surface (1/2 in.).