Cromwell Tank - Development

Development

The Cromwell and the related Centaur were the product of further development of British cruiser tanks, and they were designed as the replacement for the Crusader tank, which although not yet in service would become obsolete in time. In late 1940, the General Staff set out the specifications for the new tank, and designs were submitted in early 1941. The tank would be fitted with the QF 6 pounder gun with the expectation that it would enter service in 1942.

Due to the typical rushed production and lack of components, the A24 Cavalier, then known as "Cromwell I", built by Nuffield had far too many problems to see active combat service. One of the key problems was that its Nuffield-built Liberty engine was simply not up to the task. It had been ordered as it was based on tried equipment and therefore should have entered service with minimal delay.

Leyland and Birmingham Railway Carriage & Wagon had been involved in the development and had offered similar designs to Nuffield. A second specification for a better tank was the General Staff A27. The tank would be fitted with the QF 6 pounder gun with the expectation that it would enter service in 1942. Once it became clear there would be delays, a programme was set in place to fit the 6 pounder to the Crusader to get some 6 pounder tanks in service.

At the same time, a new engine was designed to be a tank powerplant. The Meteor engine was based on the powerful Rolls-Royce Merlin engine used in aircraft such as the Spitfire. Rolls-Royce, Leyland and BRC&W produced a prototype by January 1942 based on the Crusader but using the Meteor. With nearly 600 hp (450 kW) it proved to be exceptionally mobile when trialled. Leyland were lined up to produce the Meteor but withdrew in mid-1941 as they had doubts about being able to provide sufficient cooling. Rolls-Royce, the makers of the Merlin, were already fully committed to manufacturing the Merlin and could not spare the facilities for the Meteor, and so manufacture was passed to the Rover Car Company.

The General staff issued new specifications to cover the tanks. The BRC&W design using the Meteor was A27M (or "Cromwell III") and Leyland's version of it to take the Liberty was A27L ("Cromwell II"). Nuffields A24 with the Liberty was the Cromwell II. The naming was reworked in November 1942 with the A27L as Centaur, A27M as Cromwell and A24 as Cavalier.

Production began in November 1942. It would take considerable time for Rover to make ready production lines for the Meteor, and it was not until a few months later, in January 1943, that sufficient Meteor engines were available and the A27M Cromwell began production. The Centaur production design allowed for the later conversion to the Meteor engine and many Centaurs would be converted to Cromwells before use.