Bit Shank - Length and Leverage

Length and Leverage

The length of the shank determines the degree of leverage put on the horse's head and mouth. The leverage ratio for a typical curb bit is 1:4 (where the ratio of upper and lower cheek is 1:3), in that one ounce of pressure by the rider will result in four ounces of pressure on the mouth of the horse. Overall cheek length, from the top of the cheek ring to the bottom of the rein ring, usually cannot exceed 8½ inches for most western horse show disciplines. In Dressage the length of the lever arm portion of the cheek cannot exceed 10 cm. Cheek sizes vary from the Tom Thumb (about 4½ inches long) to bits that exceed the 8½ inch "show legal" maximum cheek length.

The relative ratio between the length of the purchase and the lever arm also affects the amount and type of leverage that is applied to the chin and poll of the horse (producing 1:3 ratio of rein to chin+poll forces in case of the typical curb bit). A long lower shank (lever arm) in relation to the upper shank (purchase) increases the leverage, and thus the pressure, on the curb groove and the bars of the mouth. This design is best suited for a longer-necked horse, as it encourages the horse to both drop its head down and bring its nose in. A somewhat long upper shank in relation to the lower shank increases the pressure on the poll, but does not apply as much pressure on the bars of the mouth. This design is often more helpful on a horse with a short and thick neck, as it encourages the horse to drop its head, but with less pressure to flex the nose in, an act that is physically more difficult for a horse with a thick neck.

Overall, a shorter-shanked bit is usually a milder bit, but also responds quickly when the rider touches the reins. Short shanked bits are usually better for a young horse transitioning from a snaffle to a curb because if the inexperienced horse gets into a place where bit pressure from the rider's hands becomes significant, there is less leverage pressure placed on the horse's head.

However, as the horse becomes more polished in its training, a somewhat longer shanked bit is preferred for its subtlety. Longer shanked bits must rotate back further before applying pressure on the horse's mouth than shorter-shanked bits. Therefore, the horse has more "warning" of a rider's hand movements in a long-shanked bit, allowing it to respond before any significant pressure is applied to its mouth. In this way, a longer shank (up to a point) can allow quieter communication between a well-trained horse and a rider with soft hands, without increasing severity of the mouthpiece.