Disadvantages
The major disadvantage is that a balloon loop is very space consuming. Another disadvantage is that the sharp curves cause noise, as well as wear on wheels and rails. Also, if the platform is located on the curve, the gap between the platform and railcar door is a hazard. The former South Ferry station on the New York City Subway solved this problem by using gap fillers that extended out to the railcar door when the train triggered a switch on the tracks. The station has since been closed.
On systems where, for reasons of economy, the couplings are made non-reversible (e.g. by fitting the air brake pipe along one side of the car only), the use of a reversing loop will cause a proportion of the rolling stock to face the "wrong" way and it may not be possible to assemble a complete train in a depot, even if sufficient cars are on hand. This was the case on the Charing Cross, Euston and Hampstead Railway (now part of the Northern line of London Underground). After the opening of a loop at Charing Cross (Embankment) in 1914 (replaced in 1926 by the present Kennington loop) car ends were marked "A" or "B" (later, when axles were designated by letters, the "B" car ends became "D" to match the adjacent axle), and it was not permitted to couple cars together if the ends to be coupled bore the same letter. It was found necessary to provide a turntable at Golders Green depot (near the other end of the line), for use when there was an imbalance of car directions.
To avoid this problem, on many systems with a balloon loop the couplings and brake hoses are made reversible.
At coal ports such as Kooragang Island the space inside the balloon loops is used for storage of coal, so that is it not wasted space.
At the Olympic Park station in Sydney, the platforms are indeed straight.
Read more about this topic: Balloon Loop