Whitby Class Frigate - Design

Design

Critical to the design of the Type 12 was the requirement to be able to steam for long periods of time in heavy seas, economically and at high speed. For this reason a novel hull form was devised, which despite appearance, was totally unrelated to that of the earlier Type 41 / Type 61 design. The hull showed the fine lines more typical of a destroyer, but had a raised forecastle with considerable flare. The fo'c'sle deck was level to maintain maximum freeboard aft of the stem where it is most likely that waves will break across the deck. These two features meant that the hull not only cut through the water, but that spray was thrown upwards and outwards, away from the bridge and gun turret. This was especially important in high latitudes where war experience had shown that spray could cause rapid and undesirable ice build-up on the forecastle. The deck edges and hull also met at a curve rather than an angle, the anchors were recessed, and protrusions were kept to a minimum to limit the potential sources of ice build-up and spray generation. The Mark 6 gunhouse was large and heavy, so had to be carried low to maintain stability and give a good view over it from the bridge. The forecastle therefore had a very distinctive kink, allowing the position of the guns to be lowered. This had the added benefit of moving the bridge aft, where there was considerably less motion, improving the lot of the watchkeeper. The hull form, coupled with a twin-shaft double-reduction geared steam turbine plant (the Y-100) that operated at high temperature and pressure (for efficiency) and low revolutions, with new five-bladed low-cavitation propellers (for efficiency and quietness) lent themselves to the perfect hull for a high-speed, all-weather anti-submarine vessel.

Experience with the Type 15 frigate program, rebuilding wartime destroyers into fast anti-submarine frigates had led to the adoption of a bridge design characteristic of Royal Navy escorts up to the Leander class of 1969. The covered bridge, where the ship was conned, was located above the operations room where the ship was fought, and there was a small pilot's position located to the front of the bridge, giving the indicative "T" shape when viewed from above. Whitby was unique in that her bridge face was vertical, her sisters having the windows mounted at an angle to the face, to cut down on internal reflections inside the bridge in low-light. There was also an open navigation bridge located above and behind the enclosed one.

The original funnel was a straight, cylindrical affair that was designed to resist a nuclear blast, but this was prone to down-draughting and did not clear the hot exhaust gasses particularly well. It was replaced by a heightened, raked, streamlined version with a characteristic domed top. This was incorporated in later build vessels, and in all of the subsequent Rothesay class. Only Scarborough retained the stubby vertical funnel throughout her career.

Read more about this topic:  Whitby Class Frigate

Famous quotes containing the word design:

    Humility is often only the putting on of a submissiveness by which men hope to bring other people to submit to them; it is a more calculated sort of pride, which debases itself with a design of being exalted; and though this vice transform itself into a thousand several shapes, yet the disguise is never more effectual nor more capable of deceiving the world than when concealed under a form of humility.
    François, Duc De La Rochefoucauld (1613–1680)

    Delay always breeds danger; and to protract a great design is often to ruin it.
    Miguel De Cervantes (1547–1616)

    We find that Good and Evil happen alike to all Men on this Side of the Grave; and as the principle Design of Tragedy is to raise Commiseration and Terror in the Minds of the Audience, we shall defeat this great End, if we always make Virtue and Innocence happy and successful.
    Joseph Addison (1672–1719)