Tin Can - Fabrication of Cans

Fabrication of Cans

Rimmed-can construction necessarily has three phases:

  1. Joining the bottom and wall (or forming the cup-shaped piece, for a two-piece can)
  2. Filling the can with content
  3. Joining the wall and top.

Rims are crucial to the joining of the wall to a top or bottom surface. An extremely tight fit between the pieces must be accomplished to prevent leakage; the process of accomplishing this radically deforms small areas of the parts. Part of the tube that forms the wall is bent, almost at its end, turning outward through 90 degrees, and then bent further, toward the middle of the tube, until it is parallel to the rest of the tube, a total bend of 180 degrees.

The outer edge of the flat piece is bent against this toward the middle of the tubular wall, until parallel with the wall, turning inward through 90 degrees. The edge of bent portion is bent further through another 90 degrees, inward now toward the axis of the tube and parallel to the main portion of the flat piece, making a total bend of 180 degrees. It is bent far enough inward that its circular edge is now slightly smaller in diameter than the edge of the tube. Bending it yet further, until it is parallel with the tube's axis, gives it a total bend of 270 degrees. Outward from the axis of the tube, the first surface is the unbent portion of the tube.

Slightly further out is a narrow portion of the top, including its edge. The outward-bent portion of the tube, including its edge, is slightly further out. Furthest out is the 90-degree-bent portion of the flat surface.

The combined interacting forces, as the portion of the flat surface adjacent to the interior of the tube is indented toward the middle of the tube and then outward froward the axis of the tube, and the other bent portions of the flat piece and the tube are all forced toward the axis of the tube, drives these five thicknesses of metal against each other from inside and out, forming a "dry" joint so tight that welding or solder is not needed to strengthen or seal it.

  • Manufacturing information on the bottom of cans.

  • Inside of a tin can.

Read more about this topic:  Tin Can

Famous quotes containing the words fabrication and/or cans:

    “Some people are under the impression that all that is required to make a good fisherman is the ability to tell lies easily and without blushing; but this is a mistake. Mere bald fabrication is useless; the veriest tyro can manage that. It is in the circumstantial detail, the embellishing touches of probability, the general air of scrupulous—almost of pedantic—veracity, that the experienced angler is seen.”
    —Jerome K. Jerome (1859–1927)

    “Are cans constitutionally iffy? Whenever, that is, we say that we can do something, or could do something, or could have done something, is there an if in the offing—suppressed, it may be, but due nevertheless to appear when we set out our sentence in full or when we give an explanation of its meaning?”
    —J.L. (John Langshaw)