Shear Zone - General Introduction

General Introduction

A shear zone is a zone of strong deformation (with a high strain rate) surrounded by rocks with a lower state of finite strain. It is characterised by a length to width ratio of more than 5:1.

Shear zones form a continuum of geological structures, ranging from brittle shear zones (or faults) via brittle–ductile shear zones (or semibrittle shear zones), ductile–brittle to ductile shear zones. In brittle shear zones, the deformation is concentrated in a narrow fracture surface separating the wall rocks, whereas in a ductile shear zone the deformation is spread out through a wider zone, the deformation state varying continuously from wall to wall. Between these end-members, there are intermediate types of brittle–ductile (semibrittle) and ductile–brittle shear zones that can combine these geometric features in different proportions.

This continuum found in the structural geometries of shear zones reflects the different deformation mechanisms reigning in the crust, i.e. the changeover from brittle (fracturing) at or near the surface to ductile (flow) deformation with increasing depth. By passing through the brittle–semibrittle transition the ductile response to deformation is starting to set in. This transition is not tied to a specific depth, but rather occurs over a certain depth range - the so-called alternating zone, where brittle fracturing and plastic flow coexist. The main reason for this is found in the usually heteromineral composition of rocks, with different minerals showing different responses to applied stresses (for instance, under stress quartz reacts plastically long before feldspars do). Thus differences in lithology, grain size, and preexisting fabrics determine a different rheological response. Yet other, purely physical factors, influence the changeover depth as well, including:

• geothermal gradient, i.e. ambient temperature.
• confinement pressure and fluid pressure.
• bulk strain rate.
• stress field orientation.

In Scholz's model for a quartzo-feldspathic crust (with a geotherm taken from Southern California), the brittle–semibrittle transition starts at about 11 km depth with an ambient temperature of 300°C. The underlying alternating zone then extends to roughly 16 km depth with a temperature of about 360°C. Below approximately 16 km depth, only ductile shear zones are found.

The seismogenic zone, in which earthquakes nucleate, is tied to the brittle domain, the schizosphere. Below an intervening alternating zone, there is the plastosphere. In the seismogenic layer, which occurs below an upper stability transition related to an upper seismicity cutoff (situated usually at about 4–5 km depth), true cataclasites start to appear. The seismogenic layer then yields to the alternating zone at 11 km depth. Yet big earthquakes can rupture both up to the surface and well into the alternating zone, sometimes even into the plastosphere.