Mold Release Agents
A good mold release agent (MRA) will allow the material to be removed quickly and effectively. Mold releases can reduce cycle times, defects, and browning of finished product. There are a number of mold release types available; they can be categorized as follows:
- Sacrificial coatings: the coating of MRA has to be applied each time because most of the MRA comes off on the molded part when it releases from the tool. Silicones are typical MRA compounds in this category.
- Semi-permanent coatings: the coating, if applied correctly, will last for a number of releases before requiring to be re-applied or touched up. This type of coating is most prevalent in today's rotational molding industry. The active chemistry involved in these coatings is typically a polysiloxane.
- Permanent coatings: most often some form of PTFE coating, which is applied to the mold. Permanent coatings avoid the need for operator application, but may become damaged by misuse.
Read more about this topic: Rotational Molding
Famous quotes containing the words mold, release and/or agents:
“O, what a noble mind is here o’erthrown!
The courtier’s, soldier’s, scholar’s,eye, tongue, sword,
Th’ expectancy and rose of the fair state,
The glass of fashion and the mold of form,
Th’ observed of all observers, quite, quite down!”
—William Shakespeare (1564–1616)
“If I were to be taken hostage, I would not plead for release nor would I want my government to be blackmailed. I think certain government officials, industrialists and celebrated persons should make it clear they are prepared to be sacrificed if taken hostage. If that were done, what gain would there be for terrorists in taking hostages?”
—Margaret Mead (1901–1978)
“The Times are the masquerade of the eternities; trivial to the dull, tokens of noble and majestic agents to the wise; the receptacle in which the Past leaves its history; the quarry out of which the genius of today is building up the Future.”
—Ralph Waldo Emerson (1803–1882)