PoR Generator
In VLSI devices, the power-on reset (PoR) is an electronic device incorporated into the integrated circuit that detects the power applied to the chip and generates a reset impulse that goes to the entire circuit placing it into a known state.
A simple PoR uses the charging of a capacitor, in series with a resistor, to measure a time period during which the rest of the circuit is held in a reset state. A Schmitt trigger may be used to deassert the reset signal cleanly, once the rising voltage of the RC network passes the threshold voltage of the Schmitt trigger. The resistor and capacitor values should be determined so that the charging of the RC network takes long enough that the supply voltage will have stabilised by the time the threshold is reached.
One of the issues with using RC network to generate PoR pulse is the sensitivity of the R and C values to the power-supply ramp characteristics. When the power supply ramp is rapid, the R and C values can be calculated so that the time to reach the switching threshold of the schmitt trigger is enough to apply a long enough reset pulse. When the power supply ramp itself is slow, the RC network tends to get charged up along with the power-supply ramp up. So when the input schmitt stage is all powered up and ready, the input voltage from the RC network would already have crossed the schmitt trigger point. This means that there might not be a reset pulse supplied to the core of the VLSI.
Read more about this topic: Power-on Reset
Famous quotes containing the word generator:
“He admired the terrible recreative power of his memory. It was only with the weakening of this generator whose fecundity diminishes with age that he could hope for his torture to be appeased. But it appeared that the power to make him suffer of one of Odette’s statements seemed exhausted, then one of these statements on which Swann’s spirit had until then not dwelled, an almost new word relayed the others and struck him with new vigor.”
—Marcel Proust (1871–1922)