Photographic Developer - Reversal Film Development

Reversal Film Development

In Ektachrome-type (E-6 process) transparencies, the film is first processed in an unusual developer containing phenidone and Hydroquinone-monosulfonate. This black and white developer is used for 6:00 at 100.4°F (38°C), with more time yielding "push" processing to increase the apparent film speed by reducing the Dmax, or maximum density. The first developer is the most critical step in Process E-6. The solution is essentially a black-and-white film developer, because it forms only a negative silver image in each layer of the film; no dye images are yet formed. Then, the film goes directly into the first wash for 2:00 at 100°F, which acts as a controlled stop bath. Next, the film goes into the reversal bath. This step prepares the film for the colour developer step. In this reversal bath, a chemical reversal agent is absorbed into the emulsion, with no chemical reaction taking place until the film enters the colour developer. The reversal process can also be carried out using 800 footcandle-seconds of light, which is used by process engineers to troubleshoot reversal bath chemistry problems.

Next, the film is developed to completion in the colour developer bath, which contains CD-3 as the colour developing agent. When film enters the colour developer, the reversal agent absorbed by the emulsion in the reversal bath chemically fogs (or "exposes") the unexposed silver halide (if it has not already been fogged by light in the previous step). The colour developer acts on the chemically exposed silver halide to form a positive silver image. However, the metallic silver image formed in the first developer, which is a negative image, is not a part of the reaction that takes place in this step. What is being reacted in this stage is the "leftover" of the negative image, that is, a positive image. As the colour development progresses, metallic silver image is formed, but more importantly, the colour developing agent is oxidised. Oxidised colour developer molecules react with the couplers to form colour dyes in situ. Thus colour dye is formed at the site of development in each of the three layers of the film. Each layer of the film contains different couplers, which react with the same oxidised developer molecules but form different colour dyes. Next, the film goes into the pre-bleach (formerly conditioner) bath, which has a precursor of formaldehyde (as a dye preservative) and EDTA to "kick off" the bleach. Next, the film goes into a bleach solution. The bleach converts metallic silver into silver bromide, which is converted to soluble silver compounds in the fixer. During bleaching, iron (III) EDTA is changed to iron (II) EDTA (Fe+++ EDTA + Ag° + Br−→ Fe++ EDTA + AgBr) before fixing, and final wash. The most common processing chemistry for such films is E6, derived from a long line of developers produced for the Ektachrome range of films.

Ektachrome papers are also available.

Standard black and white stock can also be reversal processed to give black and white slides. After 'first development,' the initial silver image is then removed (e.g. using a potassium bichromate/sulfuric acid bleach, which requires a subsequent "clearing bath" to remove the chromate stain from the film). The unfixed film is then fogged (physically or chemically) and 'second-developed'. . However the process works best with slow films such as Ilford Pan-F processed to give a high gamma. Kodak's chemistry kit for reversing Panatomic-X ("Direct Positive Film Developing Outfit") used sodium bisulfate in place of sulfuric acid in the bleach, and used a fogging developer that was inherently unstable, and had to be mixed and used within a two hour period. (If two rolls, the maximum capacity of a single pint of redeveloper, were to be processed in succession, the redeveloper had to be mixed while the first roll was in the first developer.)