Power Supplies and Logic Levels
The ECL circuits usually operate with negative power supplies (positive end of the supply is connected to ground) in contrast to other logic families in which negative end of the supply is grounded. This is done mainly to minimize the influence of the power supply variations on the logic levels as ECL is more sensitive to noise on the VCC and relatively immune to noise on VEE. Because ground should be the most stable voltage in a system, ECL is specified with a positive ground. In this connection, when the supply voltage varies, the voltage drops across the collector resistors change slightly (in the case of emitter constant current source, they do not change at all). As the collector resistors are firmly "tied up" to ground, the output voltages "move" slightly (or not at all). If the negative end of the power supply was grounded, the collector resistors would be attached to the positive rail. As the constant voltage drops across the collector resistors change slightly (or not at all), the output voltages follow the supply voltage variations and the two circuit parts act as constant current level shifters. In this case, the voltage divider R1-R2 compensates the voltage variations to some extent. The positive power supply has another disadvantage - the output voltages will vary slightly (±0.4 V) against the background of high constant voltage (+3.9 V). Another reason for using a negative power supply is protection of the output transistors from an accidental short circuit developing between output and ground (but the outputs are not protected from a short circuit with the negative rail).
The value of the supply voltage is chosen so that a sufficient current to flow through the compensating diodes D1 and D2 and the voltage drop across the common emitter resistor RE to be adequate.
ECL circuits available on the open market usually operated with logic levels incompatible with other families. This meant that interoperation between ECL and other logic families, such as the popular TTL family, required additional interface circuits. The fact that the high and low logic levels are relatively close meant that ECL suffers from small noise margins, which can be troublesome.
At least one manufacturer, IBM, made ECL circuits for use in the manufacturer's own products. The power supplies were substantially different from those used in the open market.
Positive emitter-coupled logic (PECL) is a further development of ECL using a positive 5V supply instead of a negative 5.2V supply. Low-voltage positive emitter-coupled logic (LVPECL) is a power optimized version of PECL, using a positive 3.3V instead of 5V supply. PECL and LVPECL are differential signaling systems, and are mainly used in high speed and clock distribution circuits.
Logic levels:
| Type | Vee | Vlow | Vhigh | Vcc | Vcm |
| PECL | GND | 3.4 V | 4.2 V | 5.0 V | |
| LVPECL | GND | 1.6 V | 2.4 V | 3.3 V | 2.0 V |
Read more about this topic: Low-voltage Positive Emitter-coupled Logic
Famous quotes containing the words power, supplies, logic and/or levels:
“One cannot demand of a scholar that he show himself a scholar everywhere in society, but the whole tenor of his behavior must none the less betray the thinker, he must always be instructive, his way of judging a thing must even in the smallest matters be such that people can see what it will amount to when, quietly and self-collected, he puts this power to scholarly use.”
—G.C. (Georg Christoph)
“Passion impels our deeds; ideology supplies the explanations.”
—Mason Cooley (b. 1927)
“The logic of the world is prior to all truth and falsehood.”
—Ludwig Wittgenstein (1889–1951)
“When I turned into a parent, I experienced a real and total personality change that slowly shifted back to the “normal” me, yet has not completely vanished. I believe the two levels are now superimposed, with an additional sprinkling of mortality intimations.”
—Sonia Taitz (20th century)