Fender Lead Series - Technical Information

Technical Information

Fender Lead I/III Humbucker Pickup Specifications

The DC resistance of the Lead I/III Seth Lover designed humbucker pickup is approximately 13 kΩ. The Lead I/III humbucker pickups have 12 adjustable pole pieces and have a ceramic magnet.

Fender Lead II Single Coil Pickup Specifications

The DC resistance of the Lead II X-1 single coil pickup is approximately 7.5 kΩ (9600 coil winds) vrs (7600 coil winds) on a Stratocaster. Lead II single coil pickups have flat ALNICO polepieces. Early Lead II single coil pickups have bobbins formed of green/grey fibreboard and later Lead II single coil pickups have plastic moulded bobbins that are the same as that used on current Stratocasters.

Fender Lead Series General Specifications

The Lead Series use 250 kΩ volume and tone potentiometers and use 0.05 µF tone capacitors. The body is usually made of 3 pieces of either alder or ash while the necks are maple with a walnut 'skunk stripe' on their backs and a matching plug on the face of the headstock covering the end of the truss rod.

Maple fingerboarded necks are made of one piece of maple (no separate fingerboard) while rosewood fingerboarded necks have a thick veneer of rosewood stuck over the pre-radiused face of the neck. Interestingly, while the lead neck is approximately .04 in narrower at the nut than typical Fender Telecasters and Stratocasters of that era, the neck width at the 21st fret is the same as the Stratocaster and Tele (measuring 2.182 inches).

The pickup body routing is the same for the Lead I and the Lead II models (humbucker bridge and single coil neck routing). The grounding system in all three of the series, didn't stop with the foiled backing on the pickguard. A ground strap was screwed to the body routing pocket between the bridge pickup and the pickup selector switch cavity. The body pockets were covered with a conductive coating. The bridge ground wire was connected here with a common connection to the pickguard ground.

Later year Fender Lead models have a more contoured body and there are two subtle variations in headstock shape, one of which (softer contour) used tooling dating back to the 1950s Stratocaster (as with the Dan Smith Stratocaster). Neck profile and headstock thickness varied slightly throughout the production run for all Fender Lead models of different years. Many instruments used a polyurethane finish which is brittle, chips easily, and develops spider cracks if exposed to extremes of heat or cold. The finish is also prone to clouding.