English Saddle - Parts of The English Saddle

Parts of The English Saddle

• Tree: the base on which the rest of the saddle is built, usually based on wood or a wood-like synthetic material, with metal elements added, such as the stirrup bar and, in some cases, the gullet. It is eventually covered in leather or synthetic material as the saddle is built.
• Panels: the part of an English saddle which provides cushioning between the horse's back and the saddle, and allows adjustment in fitting the saddle to the horse. Also important in keeping the saddle balanced for the rider. Often stuffed with wool or foam flocking, or maintained by sealed air pockets. The panels under the cantle are called the "rear panels." Those at the front of the saddle are called the "front panels." However, the rear and front panels are one continuous unit, which can be seen if the saddle is flipped over. The saddle has two panels total, one on each side of the horse's spine.
• Gullet: The space between the bars of the saddle which provides clearance for the horse's spine so the saddle does not place pressure on it. The gullet width of the saddle is dictated by the front arch of the tree. In some models, the angle (and thus the width) of the front arch can be adjusted on an individual saddle by use of interchangeable elements. Though imprecise terminology, the gap between the stuffed panels is colloquially referred to as the gullet.
• Seat: the dip in the saddle where the rider's seatbones rest, it is the lowest part of the saddle's topline. The deeper the seat, the more security is provided for the rider.
• Pommel: the front the saddle, which is raised higher than the seat both to provide security for the rider and to give withers clearance.
• Cantle: the back of the saddle, which is raised higher than the seat to give security.
• Waist or Twist: the part of the saddle between the seat and the pommel, on which the rider's pelvic bone rests. The width of the waist has a great effect on rider's comfort, especially for women riders.
• Skirt or Jockey: piece of leather that goes over the stirrup bar, to help prevent the rider's leg from rubbing on the buckle of the stirrup leather (which is adjusted so it is right against the stirrup bar). It also helps to keep the buckle of the stirrup leather from unbuckling and sliding down. The skirt is small to allow easy access to the stirrup leather.
• Saddle flap: The large piece of leather on the exterior of an English saddle that goes between the rider's leg and the billets and girth buckles. The shape and length of the saddle flap is directly related to the intended use of the saddle, as it must mirror the rider's leg position.
• Sweat flap: The large piece of leather on the underside of the saddle that goes between the billets and the horse. It helps to protect the rest of the saddle from the sweat of the horse, and the horse's skin from being pinched by the girth straps and buckles. In monoflap saddles it is lightweight and sewn to the saddle flap, with extended girth points enabling the girth to be buckled below the flap.
• Billets or points: Straps which are secured over the saddle tree on stout webbing and hang down, to which the girth is buckled. They have several holes in them to adjust the tightness of the girth. There are generally three billets, allowing a spare in the event one billet is torn or frayed. Some saddles have very long billets to buckle the girth below the saddle flap to reduce the bulk underneath the rider's leg, allowing for closer contact with the horse. The foremost point is usually attached to a narrow web, and the rear two to a wider web.
• Girth Buckle guard: the billets are threaded through the Girth buckle guard, which protects the saddle flap from getting worn away by the buckles of the girth. These are not always present on saddles with long billets, which are intended to be buckled below the saddle flap.
• Knee roll: the padded part at the front of the English saddle's panel and sweat flap, helping to give the rider more leg support. It may be very wide and thick, very thin (a pencil-roll), or not present at all. Additional padding on the outside flap of the saddle is sometimes added for extra grip.
• Thigh roll: the padded part at the rear of the panel's sweat flap, which lies behind the rider's thigh and can give extra stability in the saddle. Very common in dressage saddles but much less so in jumping saddles as it may interfere with freedom of movement of the rider's leg.
• Calf block: padding that falls behind the rider's lower leg, helps to keep it in place and stabilize the rider. It is only seen on a few saddle models.
• Stirrup: part of the saddle in which the rider's feet rest, provides support and leverage to the rider.
  • Stirrup Bar: part of the tree of the saddle which allows stirrups to be attached. It is made of strong metal and riveted to the tree. The stirrup bar is often kept in the "open" position, so that, should the rider fall and start to be dragged, the stirrup leather can release off the saddle, freeing the rider. There are only a few instances in which the bar should be kept in the "closed" position, and some stirrup bar designs cannot be closed.
  • Iron: The metal part of a stirrup, in which the foot of the rider rests. It provides support and leverage. It is usually made of stainless steel, not iron.
  • Leather: The part of the stirrup which attached the stirrup iron to the stirrup bar of the saddle. It can be adjusted to change the lengths of stirrups. Leathers is correct plural usage.
• Stirrup leather keeper: keeper sewn onto the saddle flap, through which the extra stirrup leather is passed. Keeps it neatly out of the way so it doesn't get under the rider's leg. Some saddles simply have a slot cut into the saddle flat, through which the leather is passed.
• D-ring or Staple: a metal ring with rounded or squared corners on the front of an English saddle, to which certain pieces of equipment, such as breastplates, can be attached. May be of stand-up or centrally hinged design. Some are stitched into leather and can be pulled out of the saddle when under stress. Some are fixed through the front arch of the tree for greater strength.