Campfire - Lighting The Fire

Lighting The Fire

Once the fire is built, the next step is to light the tinder, using either an ignition device such as a match or a lighter. A reasonably skillful fire-builder using reasonably good material will only need one match. The tinder will burn brightly, but be reduced to glowing embers within half a minute. If the kindling does not catch fire, the fire-builder must gather more tinder, determine what went wrong and try to fix it.

One of five problems can prevent a fire from lighting properly: wet wood, wet weather, too little tinder, too much wind, or a lack of oxygen. Rain will, of course, douse a fire, but a combination of wind and fog also has a stifling effect. Metal fire rings generally do a good job of keeping out wind, but some of them are so high as to impede the circulation of oxygen in a small fire. To make matters worse, these tall fire rings also make it very difficult to blow on the fire properly.

Steady, forceful blowing may be in order for a small fire in an enclosed space that has mysteriously slowed down, but blowing may extinguish a fire if it is done abruptly or when it is not needed. Most large fires easily create their own circulation, even in unfavorable conditions, but the variant log-cabin fire-build suffers from a chronic lack of air so long as the initial structure is maintained.

Once the large kindling is burning, all of the kindling should be put on the fire, save for one piece at least a foot long. This piece is useful later to push pieces of fuelwood where they are needed. Once all of the kindling is burning, the fuelwood should be placed on top of it (unless, as in the rakovalkea fire-build, it is already there). For best results, two or more pieces of fuelwood should be leaned against each other, as in the tipi fire-build.