Trim Brakes
Trim brakes are sections of brakes which are intended to adjust a train's speed during its course rather than bring the train to a complete stop. They may be engineered into a ride at its design stages at certain anticipated troubled spots, or later retrofitted once it is discovered that trains traverse certain areas at higher-than-anticipated speeds. Trim brakes are often either added for safety reasons, to lower g-forces in certain areas, or for maintenance/mechanical reasons, to lower the cost of wear-and-tear damage (especially on wooden roller coasters) caused by the trains traveling at faster than normal speeds. Usually, a proximity sensor precedes the trim brake in order to identify the current speed of the passing train. From this, the trim will then grab the train's brake fins to modify the train's speed to what the ride sets.
Read more about this topic: Brake Run
Famous quotes containing the words trim and/or brakes:
“When we think of him, he is without a hat, standing in the wind and weather. He was impatient of topcoats and hats, preferring to be exposed, and he was young enough and tough enough to enjoy the cold and the wind of those times.... It can be said of him, as of few men in a like position, that he did not fear the weather, and did not trim his sails, but instead challenged the wind itself, to improve its direction and to cause it to blow more softly and more kindly over the world and its people.”
—E.B. (Elwyn Brooks)
“There is a limit to the application of democratic methods. You can inquire of all the passengers as to what type of car they like to ride in, but it is impossible to question them as to whether to apply the brakes when the train is at full speed and accident threatens.”
—Leon Trotsky (1879–1940)