Electronic Boost Control
Electronic boost control adds an air control solenoid and/or a stepper motor controlled by an electronic control unit. The same general principle of a manual controller is present, which is to control the air pressure presented to the wastegate actuator. Further control and intelligent algorithms can be introduced, refining and increasing control over actual boost pressure delivered to the engine.
At the component level, boost pressure can either be bled out of the control lines or blocked outright. Either can achieve the goal of reducing pressure pushing against the wastegate. In a bleed-type system air is allowed to pass out of the control lines, reducing the load on the wastegate actuator. On a blocking configuration, air traveling from the charge air supply to the wastegate actuator is blocked while simultaneously bleeding any pressure that has previously built up at the wastegate actuator.
Read more about this topic: Boost Controller
Famous quotes containing the words electronic and/or control:
“The new electronic interdependence recreates the world in the image of a global village.”
—Marshall McLuhan (1911–1980)
“Our culture still holds mothers almost exclusively responsible when things go wrong with the kids. Sensing this ultimate accountability, women are understandably reluctant to give up control or veto power. If the finger of blame was eventually going to point in your direction, wouldn’t you be?”
—Ron Taffel (20th century)