Boom (sailing) - Lines On The Boom

Lines On The Boom

The control lines (ropes) on the boom act in conjunction with the halyard and leech line to ensure that the sail is trimmed most effectively.

Two primary sail control lines are attached to every boom:

• The outhaul runs from the clew of the sail to the free end of the boom. Hauling in on (tightening) the outhaul increases foot tension in the main sail. Modern loose footed sails are cut so that the outhaul is also able to pull the clew downwards towards the boom.
• The sheet is attached midway along the boom or at the free end, typically by means of a block. The block is typically attached to the boom by means of a bail, which is a U-shaped piece of metal, flattened at the ends to allow attachment with screws or rivets. In smaller boats such as dinghies it is used to control the angle of the sail to the wind on each point of sail. On largest boats this function is largely assumed by the traveller and the main sheet is used to adjust the twist of the sail to present the luff of the sail to the wind all of the way up the mast. Easing the main sheet increases twist and the twist is usually adjusted so that the aft end of the top batten in the main sail runs parallel to the boom. The traveller is a track running from one side of the boat to the other upon which sits a car to which the other end of the sheet is attached. Moving the car from side to side alters the angle of the boom to the centreline of the boat while minimising the effect on the twist of the sail.

A boom will frequently have these additional sail control lines attached:

• A downhaul may be attached to the boom near the gooseneck to pull the boom down and increase tension on the luff (forward edge) of the sail. If no downhaul is present, the gooseneck is usually fixed vertically to the mast and a cunningham may be used to control luff tension.
• The boom vang, kicking strap or kicker is an intricate set of pulleys (and, on yachts, a hydraulic ram) running diagonally between the boom and the lower portion of the mast. The kicker pulls the boom downwards. When the boat is running away from the wind the sheet will be fully eased and so the kicker becomes the primary means of controlling sail twist.
• The Preventer, prevents the boom from jibing. This line is run from a point on the boom to a point forward such as a deck cleat or the base of a stanchion. Ideally, the preventer should run from the aft end of the boom to a turning block at or very close to the bow and then back to a cleat convenient to the cockpit. The line does not take tremendous force if used properly, but it prevents the boom from starting a jibe if the wind shifts or the boat rolls. Sophisticated form of preventer is a Boom Brake, which not only prevents unwanted jibes, but allows a slow measured jibe by modulating the tension on the brake.
• Reef Lines, are used to tie-off excess sail, when sails are reefed (shortened). Some modern systems known as "jiffy reefing" or "slab reefing" have permanent lines running through the boom for purposes of reefing. Pulling on these lines helps to gather the excess sail at the bottom of the boom, and to secure the reef points to the fore and aft of the boom. With a well designed system sailors can reef the sails without leaving the cockpit.

Other lines that may found on a boom include:

• A topping lift, holds up the free end of the boom when the sail is lowered.
• Lazy jacks guide the sail onto the top of the boom for furling when the sail is lowered.
• A pair of Anti-Jibe Preventer lines that prevents the boom from rotating during an accidental Jibe or Gybe.