Bass Guitar - Design Considerations

Design Considerations

Bass bodies are typically made of wood, although other materials such as graphite (for example, some of the Steinberger designs) have also been used. While a wide variety of woods are suitable for use in the body, neck, and fretboard of the bass guitar, the most common type of wood used for the body is alder, for the neck is maple, and for the fretboard is rosewood. Other commonly used woods include mahogany, maple, ash, walnut, and poplar for bodies, mahogany for necks, and maple and ebony for fretboards.

Other design options include finishes, such as lacquer, wax and oil; flat and carved designs; Luthier-produced custom-designed instruments; headless basses, which have tuning machines in the bridge of the instrument (e.g., Steinberger and Hohner designs) and several artificial materials such as luthite. The use of artificial materials (e.g., BassLab) allows for unique production techniques such as die-casting, to produce complex body shapes. While most basses have solid bodies, they can also include hollow chambers to increase the resonance or reduce the weight of the instrument. Some basses are built with entirely hollow bodies, which change the tone and resonance of the instrument. Acoustic bass guitars are typically equipped with piezoelectric or magnetic pickups and amplified.

Instruments handmade by highly skilled luthiers are becoming increasingly available. Exotic materials include woods such as bubinga, wenge, ovangkol, ebony and goncalo alves. Graphite composite is used to make lightweight necks Exotic woods are used on more expensive instruments: for example, Alembic uses cocobolo as a body or top layer material because of its attractive grain. Warwick bass guitars are also well known for exotic hardwoods: most of the necks are made of ovangkol, and the fingerboards wenge or ebony. Solid bubinga bodies are also used for tonal and aesthetic qualities.

A common feature of more expensive basses is "neck-through" construction. Instead of milling the body from a single piece of wood (or "bookmatched" halves) and then attaching the neck into a pocket (so-called "bolt-on" design), neck-through bases are constructed first by assembling the neck, which may comprise one, three, five or more layers of wood in vertical stripes, which are longer than the length of the fretboard. To this elongated neck, the body is attached as two wings, which may also be made up of several layers. The entire bass is then milled and shaped. Many players believe neck-through construction provides better sustain and a mellower tone than bolt-on neck construction. While neck-through construction is most common in handmade "boutique" basses, some models of mass-produced basses such as Ibanez's BTB series also have neck-through construction. Bolt-on neck construction doesn't necessarily imply a cheaply made instrument; virtually all traditional Fender designs still use bolt-on necks for instruments costing thousands of dollars, and many boutique luthiers will build bolt-on basses as well as neck-through.

The long scale necks on Leo Fender's basses—with a scale length (distance between nut and bridge) of 34 inches—set the standard for electric basses. However, 30 inch "short scale" instruments, such as the Höfner 500/1 "violin bass" played by Paul McCartney, and the Fender Mustang Bass are popular, especially for players with smaller hands. While 35", 35.5" and 36" scale lengths were once only available in "boutique" instruments, in the 2000s (decade), many manufacturers began offering these "extra long" scale lengths. This extra long scale provides a higher string tension, which may yield a more defined tone on the low "B" string of five- and six-stringed instruments (or detuned four-string basses).