Design Features
Then dimensions of these engines were largely the same as those of the Class IV b. However the double frame was dropped and replaced by a simple plate frame. The engine had a very short wheelbase and as a result good curve-running performance. In addition the carrying axle had a side play of 10 mm. It was returned to its centre position by sloping bearing surfaces (geneigte Doppelflächen). The grate area of the firebox turned out to be very small; as a result its steam generation was not particularly satisfactory. Trials with ribbed tubes did not produce any improvements. The large steam dome sat on the rear boiler section.
The outside wet-steam engine had inside valves and drove the first coupled axle. The wheels were sprung with leaf springs located over the top, that were linked by a compensating lever between the coupled wheels.
The vehicles were equipped with tenders of classes 2 T 8 or 2 T 6.67. Several locomotives were equipped with rearward-facing driver's cabs on tenders. This enabled them to work routes without a turntable.
Read more about this topic: Baden IV C
Famous quotes containing the words design and/or features:
“I begin with a design for a hearse.
For Christ’s sake not black—
nor white either—and not polished!
Let it be weathered—like a farm wagon—”
—William Carlos Williams (1883–1963)
“All visible objects, man, are but as pasteboard masks. But in each event—in the living act, the undoubted deed—there, some unknown but still reasoning thing puts forth the mouldings of its features from behind the unreasoning mask. If man will strike, strike through the mask!”
—Herman Melville (1819–1891)