GEN-3 AMC Tall-deck (1970-1991)
In 1970, all three blocks grew in deck height and gained a new head design. These changes made this the third generation of AMC V-8, hence it is sometimes referred to as the GEN-3 AMC V-8. The stroke and deck height on the 290 and 343 was increased by 0.16 in (~5/32 in), becoming the 304 cu in (5.0 L) and 360 cu in (5.9 L), respectively. The 1970 AMX 390 remained at the same displacement by using a special rod and piston for this year only. It is believed that AMC kept the 390 this last year due to the reputation it had garnered in the two seater AMX, which was discontinued after 1970. In 1971 the 390 was stroked by 0.16 in to become the 401.
The other change in 1970 was the switch to the dog-leg heads. These heads flow ~20% better on the exhaust side than the 1966-69 rectangle port heads and are thus the best for performance. There are two reasons for the flow increase: First, the area of the port is larger, due to the dog leg. Second, the shape of the port floor was changed from a concave to a convex curve. The concave floor tended to bend the exhaust flow upwards which caused turbulence when the flow was forced to go down into the exhaust manifolds. By switching to a convex floor the curvature of the flow starts in the head and proceeds much more smoothly into the exhaust manifold resulting in less turbulence and better flow.
The center two intake bolts on each head were relocated to prevent accidental mix-ups of GEN-2 and GEN-3 intakes. The intakes can be interchanged by slotting the bolt holes, but the added deck height of the GEN-3 engine means that sealing and port match will be compromised. GEN-3 intakes can be machined to fit GEN-2 engines by surface grinding the intake flanges (by a machine shop) and slotting the center holes.
There is a persistent myth about 1970-mid 1971 "319" or "291" AMC heads. These heads have the dog-leg exhaust ports and 50-52 cc combustion chambers. They are commonly identified by the first three (319) or last three (291 for the 360-401 heads; 304 used a different casting) digits of the casting number. There was a U.S. auto industry-wide shift to lower compression ratios in mid 1971, so AMC increased combustion chamber size to 58-59 cc. The first three digits of the casting number on the large chamber heads are 321, 322, or 323 depending on year. The only difference between small and large chamber GEN-3 heads is the combustion chamber size. The early heads are not "the best" AMC heads as many have come to believe. They will raise compression on a later engine with no other changes, but if building an engine get the proper pistons for the desired ratio. There is no reason to search out these relatively hard to find, and more expensive when found, heads for performance.
Read more about this topic: AMC V8 Engine